期刊文献+

辐射方向对木材引燃特性影响的实验研究 被引量:3

AN EXPERIMENT STUDY OF RADIATION ORIENTATION EFFECT ON PILOTED IGNITION OF WOOD
原文传递
导出
摘要 在有点火源的条件下,对榆木在两种不同辐射方向下的热解和着火特性进行了研究,测定了不同外加热辐射强度、不同辐射方向下榆木的着火时间、表面温度、质量损失的变化规律。实验结果表明,榆木在水平方向下较垂直方向更容易着火,临界热流更小,着火表面温度更高,质量损失速率更小。 The effect of radiation orientation on pyrolysis and piloted ignition of Elmwood under different heat flux has been experimentally investigated. Two orientations were selected, vertical or horizontal, according to the geometry of materials in the actual fire scene. Ignition time, surface tern- perature profiles, mass loss rate and critical heat flux were all measured in the experiments. Compared with the vertical orientation, the samples burned much easier and lower critical heat flux for pilot ignition, higher surface temperature and smaller mass loss rate were revealed for the horizontal orientation.
出处 《工程热物理学报》 EI CAS CSCD 北大核心 2010年第12期2133-2136,共4页 Journal of Engineering Thermophysics
基金 国家自然科学基金项目资助(No.50976111)
关键词 热解 着火 辐射热流 辐射方向 引燃 pyrolysis ignition heat flux radiation orientation piloted ignition
  • 相关文献

参考文献11

  • 1Babrauska V. Ignition of Wood: A Review of the State of the Art [J]. J. Fire Prot. Eng., 2002, 12:163-189.
  • 2Kashiwagi T. Effects of Sample Orientation on Radiative Ignition [J]. Combust Flame, 1982, 44:223-245.
  • 3Atreya A, Carpentier C, Harkleroad M. Effect of Sample Orientation on Piloted Ignition and Flame Spread [J]. Fire Safety Sci. 1st Int. Symp., 1986:97-109.
  • 4Shields T J, Sileock G W, Murray J J. The Effects of Geometry and Ignition Mode on Ignition Times Obtained Using a Cone Calorimeter [J]. Fire Mater, 1993, 17:25-32.
  • 5Babrauskas V. Ignition Handbook [M]. Fire Science Publishers, 2003: 294-295, chapter 7.
  • 6Nakamura Y J, Kashiwagi T. Effects of Sample Orientation on Nonpiloted Ignition of Thin Poly (Methyl Methacrylate) Sheets by a Laser 1. Theoretical Prediction [J]. Combust Flame, 2005, 141:149-169.
  • 7Gotoda H, Manzello S L, SasoY, et al. Effects of Sample Orientation on Nonpiloted Ignition of Thin Poly (Methyl Methacrylate) Sheets by a Laser 2. Experimental Results [J]. Combust Flame, 2006, 145:820-835.
  • 8Merryweather G, Spearpoint M J. Ignition of New Zealand Wood Products in the LIFT, RIFT and ISO 5657 Apparatus Using the ASTM E 1321-97 Protocol [J]. J. Fire Sci., 2008, 26(1): 63 -88.
  • 9Tsai K C, Orientation Effect on Cone Calorimeter Test Results to Assess Fire Hazard of Materials [J]. J. Hazard Mater, 2009, 172(2-3): 763-772.
  • 10杨立中,郭再富.变热流条件下木材点燃时间与热流变化率关系的实验研究[J].热科学与技术,2005,4(3):224-227. 被引量:5

二级参考文献11

  • 1MIKKOLA E, WICHMAN I S. On the thermal ignition of combustible materials [J]. Fire and Materials, 1989, 14: 87-96.
  • 2DELICHATSIOS M A, PANAGIOTOU T H, KILEY F. The use of time to ignition data for characterizing the thermal inertia and the minimum (critical) heat flux for ignition or pyrolysis [J]. Combustion and Flame, 1991, 84: 323-332.
  • 3SPEARPOINT M J. Predicting the ignition and burning rate of wood in the cone calorimeter using an integral model [R]∥ NIST, GCR 99-775, 1999:425.
  • 4BILBAO R, MASTRAL J F, LANA J A, et al. A model for the prediction of the thermal degradation and ignition of wood under constant and variable heat flux [J]. J of Analytical and Applied Pyrolysis, 2002, 62: 63-82.
  • 5YANG L Z, DENG Z H, FAN W C, et al. Experimental study on characteristics at early stage of fire-measurement and analysis on early development of flame image area [J]. J of Fire Sci, 2001, 19(3):190-203.
  • 6QUINTIERE J G, HAKLEROAD M. New concepts for measuring flame spread properties [C]∥ Fire Safety: Scie and Eng, ASTM STP 882. Philadephia: American Society for Testing and Materials, 1985: 239-267.
  • 7TEWARSON A. Generation of heat and chemical compounds in fires [Z]∥ The SFPE Handbook of Fire Protection Eng. Quincy: NFPA, 1995.
  • 8TOAL B R, SILCOCK G W H, SHIELDS T J. An examination of piloted ignition characteristics of cellulosic materials using the ISO ignitability test [J]. Fire and Materials, 1989, 14: 97-106.
  • 9SHIELDS T J, SILCOCK G W H, MURRAY J J. Evaluating ignition data using the flux time product [J]. Fire and Materials, 1994, 18: 243-254.
  • 10SILCOCK G W H, SHIELDS T J. A protocol for analysis of time-to-ignition data from bench scale tests [J]. Fire Safety J, 1995, 24: 75-95.

共引文献4

同被引文献20

引证文献3

二级引证文献20

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部