期刊文献+

具有网络丢包和时延的网络控制系统设计 被引量:24

Design of networked controller for systems with packet dropout and networked-induced delays
原文传递
导出
摘要 为了降低对于网络传输的要求,针对具有固定时延和随机丢包情况的网络系统,采用状态增广以克服时延对网络控制系统分析的影响,进而考虑随机丢包情况,将增广系统转化为切换系统.以此为基础,提出网络鲁棒控制器设计方法.该控制器仅仅基于被控对象的反馈状态,因此对于网络传输的要求较低.最后,通过一个仿真算例验证了该系统的有效性. In order to reduce the communication burden of networks,for systems with fixed networked-induced delays and random data packets dropout,the system is augmented to eliminate the effect caused by networked-induced delays.Then the augmented system is converted into a switched system to include the data packets dropout.Based on the switched system model,the design method of networked robust controller is proposed,which only adopts the feedback system state of original system and can reduce the communication request.Finally,a simulation example shows the effectiveness of the results.
作者 陈青 吴敏
出处 《控制与决策》 EI CSCD 北大核心 2011年第2期293-296,共4页 Control and Decision
基金 国家杰出青年科学基金项目(60425310)
关键词 网络控制系统 网络丢包 切换系统 鲁棒 networked control system packet dropout switched system robust
  • 相关文献

参考文献10

  • 1Montestruque L A, Antsaklis P. Stability of model-based networked control systems with time-varying transmission times[J]. IEEE Trans on Automatic Control, 2004, 49(9): 1562-1572.
  • 2李德伟,席裕庚.预估网络控制系统的设计和分析[J].控制与决策,2007,22(9):1065-1069. 被引量:12
  • 3张奇智,张卫东.网络控制系统中的时戳预测函数控制[J].控制理论与应用,2006,23(1):126-130. 被引量:7
  • 4聂雪媛,王恒.网络控制系统补偿器设计及稳定性分析[J].控制理论与应用,2008,25(2):217-222. 被引量:14
  • 5De La Pena D M, Christofides P D. Lyapunov-based model predictive control of nonlinear systems subject to data losses[J]. IEEE Trans on Automatic Control, 2008, 53(9): 2076-2089.
  • 6Montestruque L A, Antsaklis P J. On the modelbased control of networked systems[J]. Automatica, 2003, 39(10): 1837-1843.
  • 7Matveev A S, Savkin A V. The problem of state estimation via asynchronous communication channel with irregular transmission times[J]. IEEE Trans on Automatic Control, 2003, 48(4): 670-676.
  • 8Zhang W A, Yu L. Modeling and control of networked control systems with both network-induced delay and packet-dropout[J]. Automatica, 2008, 44(12): 3206-3210.
  • 9Gao H J, Meng X Y, Chen T W. Stabilization of networked control systems with a new delay characterization[J]. IEEE Trans on Automatic Control, 2008, 53(9): 2142-2148.
  • 10Xiong J L, Lam J. Stabilization of networked control systems with a logic ZOH[J]. IEEE Trans on Automatic Control, 2009, 54(2): 358-363.

二级参考文献27

  • 1刘磊明,童朝南,袁立.关于网络控制系统中的延迟对系统性能影响的研究[J].信息与控制,2005,34(3):263-268. 被引量:14
  • 2聂雪媛,刘国平.基于Simulink的嵌入式网络化控制仿真实现[J].系统仿真学报,2005,17(7):1613-1616. 被引量:12
  • 3LUCK R,RAY A.An observer-based compensator for distributed delays [J].Automatica,1990,26 (5):903-908.
  • 4LUCK R,RAY A.Experimental verification of a delay compensation algorithm for integrated communication and control systems [J].Int J of Control,1994,59(6):1357-1372.
  • 5GOKTAS F.Distributed control of systems over communication networks [D].USA:Department of Computer and Information Science,University of Pennsylvania,2000.
  • 6NILSSON J.Real-time control systems with delays [D].Sweden:Department of Automatic Control,Lund Institute of Technology,1998.
  • 7SRINIVASAGUPTA D,SCHATTLER H,JOSEPH B.Timestamped model predictive control:An algorithm for control of processes with random delays [J].Computers & Chemical Engineering,2004,28 (8):1337-1346.
  • 8RICHALET J,ESTIVAL J L,FIANI P.Industrial applications of predictive functional control to metallurgical industries [C]//Proceedings of the 4th IEEE Conference on Control Applications.New York:IEEE Press,1995:934-942.
  • 9HENRIKSSON D,CERVIN A,ARZEN K E.TrueTime:Simulation of control loops under shared computer resources [C]// Proceedings of the 15th IFAC.Barcelona,Spain:Elsevier Science,2002.
  • 10HENRIKSSON D,CERVIN A.TrueTime 1.13 reference manual [EB/OL].Lund,Sweden:Department of Automatic Control,Lund Institute of Technology,[2003-03-28 ].http://www.control.1th.se/~ dan/truetime.

共引文献22

同被引文献203

引证文献24

二级引证文献66

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部