摘要
采用微弧氧化在钛合金表面制备BaTiO3膜。讨论电解液组分、反应时间及电压对BaTiO3膜形态和相组成的影响,并评价BaTiO3膜的结合强度。结果表明,BaTiO3的生成量随电解液浓度和氧化时间的增大而增加;其表面形貌也受电解液浓度、电压和氧化时间的影响;电压降低,膜层的结合强度有增大的趋势。电压为80 V时,结合强度可达36.4 MPa,优于一般等离子喷涂技术获得的膜层结合强度。
The barium titanate films have been grown on the surface of the titanium alloy by the micro-arc oxidation.The effect of the electrolyte composition,oxidation time,and micro-arc voltage on the structure and morphology of the films were discussed,and the adhesive strength of the BaTiO3 films was evaluated.The results showed that with increasing the concentration of electrolyte composition and oxidation time the more barium titanate films were formed.The morphology of the BaTiO3 films was influenced by the concentration of the electrolyte composition and the voltage as well as the oxidation time.With the decreasing of the voltage,the adhesive strength of the film layer tended to increase.At the voltage of 80 V,the adhesive strength can reach 36.4 MPa,which is much higher than that of the coatings by general plasma spraying technique.
出处
《压电与声光》
CSCD
北大核心
2011年第1期143-146,共4页
Piezoelectrics & Acoustooptics
关键词
钛酸钡膜
制备
结构
结合强度
微弧氧化
barium titanate film
preparation
structural characterization
adhesive strength
micro-arc oxidation