期刊文献+

面贴式永磁电机转子位置估计中的高频负序电流谐波研究 被引量:2

Research on High-frequency Negative Current Harmonics in Rotor Position Estimation of SMPMM
下载PDF
导出
摘要 利用旋转高频信号注入法面贴式永磁同步电机转子位置时,由于各种因素的影响,高频负序电流中将含有各种谐波,这些谐波给转子位置的估计带来极大的误差。本文对这一问题进行了理论研究和实验验证,初步阐释了负序电流谐波产生的原因及造成的影响,并提出了相应的解决办法。 When using the method of rotating high - frequency voltage injection to estimate the rotor position of Surface- Mounted Permanent- Magnet Machine( SMPMM), the negative current harmonics, which resulted from the asymmetry of the distribution of high - frequency inductance , wilt give rise to some errors to the rotor position estimation. This paper discussed this issue from both hand of theory and experiment, and primitively demonstrated the reason the negative current harmonics occurred and its effects. The measures to solve it were also presented.
作者 钟黎萍 李鑫
出处 《电测与仪表》 北大核心 2011年第2期21-25,30,共6页 Electrical Measurement & Instrumentation
关键词 饱和凸极 非对称性 负序电流谐波 saturation -induced saliencies, asymmetry, negative current harmonics
  • 相关文献

参考文献17

  • 1Ji-Hoon Jang,Jung-IK Ha.Analysis of permanent-magnet machine for sensorless control based on high-frequency signal injection[J].IEEE transactions on industry applications,2004,40(6):1595-1602.
  • 2刘毅,贺益康,秦峰,贾洪平.基于转子凸极跟踪的无位置传感器永磁同步电机矢量控制研究[J].中国电机工程学报,2005,25(17):121-126. 被引量:99
  • 3王丽梅,郑建芬,郭庆鼎.基于载波注入的凸极永磁同步电动机无传感器控制[J].电机与控制学报,2005,9(4):333-336. 被引量:37
  • 4Fernando Briz,Robert D.Lorendz et al.Comparison of saliency-based sensorless control techniques for AC machines[J].IEEE transactions on industry applications,2004,40(4):1107-1114.
  • 5Riberio L A S,Lorenz R D.Comparison of carrier signal voltage and current injection for the estimation of flux angle or rotor position[C].IEEE IAS Conf.Rec.,St.Louis,1998:452-459.
  • 6秦峰,贺益康,刘毅,章玮.永磁同步电机转子位置的无传感器自检测[J].浙江大学学报(工学版),2004,38(4):465-469. 被引量:49
  • 7秦峰,贺益康,刘毅,章玮.两种高频信号注入法的无传感器运行研究[J].中国电机工程学报,2005,25(5):116-121. 被引量:216
  • 8H.Tajima,Y.Horiz.Speed sensorless field orientation control of the induction machine[J].IEEE Trans.on Industry Applications,1993,29:175-180.
  • 9F.Briz,M.Degner.Position estimation in induction machines utilizing rotor bar slot harmonics and carrier frequency signal injection[J].IEEE Trans.on Industry Applications,2002,36:736-742.
  • 10N.Bianchi,S.Bolognani.High-performance PM synchronous motor drive for an electrical scooter[J].IEEE Trans.on Industry Applications,2001,37(5):1348-1355.

二级参考文献30

  • 1年珩,贺益康,秦峰,刘毅.永磁型无轴承电机的无传感器运行研究[J].中国电机工程学报,2004,24(11):101-105. 被引量:27
  • 2刘毅,贺益康,秦峰,章玮.基于传感器集成概念的永磁同步电机转子位置检测[J].电工电能新技术,2004,23(4):60-64. 被引量:7
  • 3秦峰,贺益康,刘毅,章玮.两种高频信号注入法的无传感器运行研究[J].中国电机工程学报,2005,25(5):116-121. 被引量:216
  • 4Ribeiro L A S, Degner M W, Lorenz R D. Comprison of carder signal voltage and current injection for the estimation of flux angle or rotor position[C]. IEEE IAS Conf. Rec., St. Louis, 1998: 452-459.
  • 5Jang J H, Sul S K, Ha J I. Sensorless drive of surface-mounted permanent-magnet motor by high-frequency signal injection based on magnetic saliency[J]. IEEE. Trans.on Industry Application, 2003,39(4): 1031-1038.
  • 6Lorenz R D. Practical issues and research opportunities when implementing zero speed sensorless control[C]. Proceedings of the Fifth International Conference on Electrical Machines and Systems. Shenyang, China, 2001: 1-10.
  • 7Wang Limei, Guo Qingding, Lorenz R D. Sensorless control of permanent magnet synchronous motor[C]. Proceedings of Power Electronics and Motion Control Conference. Beijing,China, 2000:186-190.
  • 8Degner M W, Lorenz R D. Using multiple saliencies for the estimation of flux, position and velocity in AC machines[C]. IEEE. IAS Conf. Rec., New Orleans. 1997: 760-767.
  • 9Degner M W. Lorenz R D. Position estimation in induction machines utilizing rotor bar slot harmonics and carrier frequency signal injection[C]. IEEE. IAS, PCC Nagooka Tech. Conf. Rec., Nagaoka,Japan, 1997: 69-72.
  • 10Lorenz R D. Practical issues and research opportunities when implementing zero speed sensorless control[C]. Shenyang :Proceedings of the Fifth International Conference on Electrical Machines and Systems, 2001.

共引文献320

同被引文献22

引证文献2

二级引证文献6

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部