期刊文献+

不同全瓷材料修复种植体支持单冠的应力分析 被引量:6

Stress Analysis of Implant-supported Single Crown Restored with Different All-ceramic Materials
原文传递
导出
摘要 用COSMOSM 2.85软件包建立了种植体支持的上颌中切牙三维有限元模型,观察在斜向加载时全瓷冠、全瓷基台和种植体周围骨组织内部的应力情况。全瓷基台设计为Procera氧化锆,全瓷冠分别选用Procera,In-ceram,IPSEmpress 2和Cercon等全瓷材料进行修复。研究表明:不同全瓷材料修复时全瓷冠、全瓷基台和种植体周围骨组织内部的应力分布相似。全瓷冠内部的应力集中在近远中颈部区域,全瓷基台内部的应力集中在腭侧种植体-基台连接处和基台-冠连接处,种植体周围骨组织内部的应力集中在唇侧颈部皮质骨。全瓷冠内部最大张应力在Procera氧化铝修复时最大,比IPS Empress 2修复时高约34%。全瓷基台和骨组织内部的最大应力在不同全瓷修复时差异不大,最大和最小值相差在4%~9%。 In this paper,a 3-D finite element model of an implant-supported single crwon for maxillary central incisor was computed by COSMOSM 2.85.The stresses within the all-ceramic crown,abutment and peri-implant bone were observed under oblique loading.The materials used for abutment was Procera zirconia and for crown was Procera,In-ceram,IPS Empress 2 and Cercon,respectively.The results shown that the stress distribution within the all-ceramic crown,abutment and peri-implant bone was similar when different all-ceramic materials were used.Within the all-ceramic crown the stress was concentrated near the neck of crown in the misal and distal side,within the abutment was at the implant-abutment junction and implant-crown junction and within the peri-implant bone was near the neck of cortical bone.The maximum tensile stress within the all-ceramic crown was highest when Procera alumina was used,which was 34% higher than that of IPS Empress 2.The difference of the maximum stress within the abutment and peri-implant bone was not significant.
出处 《武汉理工大学学报》 CAS CSCD 北大核心 2010年第23期27-30,共4页 Journal of Wuhan University of Technology
基金 "十一五"国家科技支撑计划(2007BAI18B05)
关键词 种植体 全瓷材料 应力分析 三维有限元模型 implant all-ceramic stress analysis 3-D finite element model
  • 相关文献

参考文献11

  • 1李智勇,牛薇,方伟,胡建,王贻宁.瓷基台和钛基台用于种植体支持全瓷单冠修复的临床观察[J].中华口腔医学杂志,2007,42(7):391-394. 被引量:17
  • 2Glauser R, Sailer I, Wohlwend A, et al. Experimental Zirconia Abutments for Implant-supported Single-tooth Restorations in Esthetically Demanding Regions: 4-year Results of a Prospective Clinical Study[J ]. Int J Prosthodont, 2004,17(3):285-290.
  • 3Zembic A, Sailer I, Jung RE, et al. Randomized-controlled Clinical Trial of Customized Zirconia and Titanium Implanf Abutments for Single-tooth Implants in Canine and Posterior Regions: 3-year Results[J 1. Clin Oral Implants Res, 2009,20 (8) :802- 808.
  • 4陈轶珺.氧化锆全瓷角度基台的三维有限元应力分析[J].口腔医学研究,2008,24(3):317-319. 被引量:11
  • 5Saab X E, Griggs J A, Powers J M, et al. Effect of Abutment Angulation on the Strain on the Bone Around an Implant in the Anterior Maxilla. A Finite Element Study [ J ]. J Prosthet Dent, 2007,97 (2) : 85-92.
  • 6Andersson B, Glauser R, Maglione M, et al. Ceramic Implant Abutments for Short-span FPDs: a Prospective 5-year Multicenter Study[J]. Int J Prosthcdont 2003,16(6) :640-646.
  • 7Att W, Kurun S, Gerds T, et al. Fracture Resistance of Single-tooth Implant-supported All-ceramic Restorations After Exposure to the Artificial Mouth[J]. J Oral Rehabil,2006,33(5):380-386.
  • 8Yildirim M, Fischer H, Marx R, et al. In Vivo Fracture Resistance of Implant-supported All-ceramic Restorations[J]. J Prosthet Dent,2003,90(4) :325-331.
  • 9Pallis K, Griggs J A, Woody R D, et al. Fracture Resistance of Three All-ceramic Restorative Systems for Posterior Applications[J ]. J Prosthet Dent, 2004,91(6) : 561-569.
  • 10Conrad H J, Seong W J, Pesun I J. Current Ceramic Materials and Systems with Clinical Recommendations: A Systematic Review[ J ]. J Prosthet Dent, 2007,98 (5) : 389-404.

二级参考文献30

共引文献37

同被引文献47

  • 1李国华,陈吉华.牙科全瓷材料3Y-TZP生物相容性初步评价[J].口腔医学研究,2007,23(1):4-6. 被引量:12
  • 2王惠芸.我国人牙的测量和统计[J].中华口腔科杂志,1959,7(3):149-155.
  • 3Burke FJ, Fleming GJ, Nathanson D, et al. Are adhesive technologies needed to support ceramics? An assessment of the current evidence [J]. J Adhes Dent, 2002, 4(1): 7-22.
  • 4Rekow ED, Harsono M, Janal M, et al. Factorial analysis of variables influencing stress in all- ceramic crowns [J]. Dent Mater, 2006, 22(2): 125-132.
  • 5Liu B, Lu C, Wu Y, et al. The effects of adhesive type and thickness on stress distribution in molars restored with all- ceramic crowns [J]. J Prosthodont, 2011, 20(1): 35-44.
  • 6Fischer H, Weber M, Marx R. Lifetime prediction of all-ceramic bridges by computational methods[J].J Dent Res,2003,82(3):238-242.
  • 7Imanishi A, Nakamura T, Ohyama T, et al. 3-D Finite element analysis of all-ceramic posterior crowns [J]. J Oral Rehabil, 2003, 30(8): 818-822.
  • 8Rekow ED, Harsono M, Janal M, et al. Factorial analysis of variables influencing stress in all-ceramic crowns[J]. Dent Mater, 2006, 22(2): 125-132.
  • 9皮听.口腔解剖生理学[M].第5版.北京:人民卫生出版社,2004:250-257.
  • 10Rafferty BT, Janal MN, Zavanelli RA, et al. Design features of a three-dimensional molar crown and related maximum principal stress. A finite element model study [J]. Dent Mater,2010,26(2):156-163.

引证文献6

二级引证文献28

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部