摘要
We investigated the effects of molecular weight and film thickness on the crystallization and microphase separation in semicrystalline block copolymer polystyrene-block-poly（L-lactic acid） （PS-b-PLLA） thin films, at the early stage of film evolution （when Tg 〈 T 〈 TODT） by in situ hot stage atomic force microscopy. For PS-b-PLLA 1 copolymer which had lower molecular weight and higher PLLA fraction, diffusion-controlled break-out crystallization started easily. For PS-b-PLLA 2 with higher molecular weight, crystallization in nanometer scales occurs in local area. After melting of the two copolymer films, islands were observed at the film surface： PS-b-PLLA 1 film was in a disordered phase mixed state while PS-b-PLLA 2 film formed phase-separated lamellar structure paralleling to the substrate. Crystallization-melting and van der Waals forces drove the island formation in PS-b-PLLA 1 film. Film thickness affected the crystallization rate. Crystals grew very slowly in much thinner film of PS-b-PLLA 1 and remained almost unchanged at long time annealing. The incompatibility between PS and PLLA blocks drove the film fluctuation which subsequently evolved into spinodal-like morphology.
We investigated the effects of molecular weight and film thickness on the crystallization and microphase separation in semicrystalline block copolymer polystyrene-block-poly（L-lactic acid） （PS-b-PLLA） thin films, at the early stage of film evolution （when Tg 〈 T 〈 TODT） by in situ hot stage atomic force microscopy. For PS-b-PLLA 1 copolymer which had lower molecular weight and higher PLLA fraction, diffusion-controlled break-out crystallization started easily. For PS-b-PLLA 2 with higher molecular weight, crystallization in nanometer scales occurs in local area. After melting of the two copolymer films, islands were observed at the film surface： PS-b-PLLA 1 film was in a disordered phase mixed state while PS-b-PLLA 2 film formed phase-separated lamellar structure paralleling to the substrate. Crystallization-melting and van der Waals forces drove the island formation in PS-b-PLLA 1 film. Film thickness affected the crystallization rate. Crystals grew very slowly in much thinner film of PS-b-PLLA 1 and remained almost unchanged at long time annealing. The incompatibility between PS and PLLA blocks drove the film fluctuation which subsequently evolved into spinodal-like morphology.
基金
supported by the National Natural Science Foundation of China(Nos.20621401,50773080, 20834005)
the Ministry of Science and Technology of China(No.2009CB930603)
