期刊文献+

CuZn37Mn3Al2FeSi合金组织和性能的研究(续) 被引量:1

Study on Microstructure and Properties of CuZn37Mn3Al2FeSi Alloy
下载PDF
导出
摘要 从图4中可以看出,在300℃下时效1小时,组织中只有微量的α相析出,大部分为β相,当时效温度升高到350℃时,α相大量以针状在晶内析出,晶界有少量球状α相;在380℃和420℃时效1小时后,α相不仅仅以针状在晶内析出,晶界上也有很多球状α相,且数量明显增多; The microstructure of Cu-37%Zn-2%Mn-1.6%Al-0.7%Fe-0.7%Si(mass fraction)alloy was studied by scanning electron microscopy,X-ray and optical microscopy.The α phase ratio and micro-hardness of this alloy after aging treatment were investigated.The results show that three kinds of phases,such as α phase,β phase and hexagonal club-shape Mn5Si3 phase were observed.The needle α phase ratio increases with aging temperature under 420℃ and reach peak value 25 percent after aging at 420℃×1h.The α phase ratio begin to decreases when the aging temperature over 420℃.The micro-hardness varying with aging temperature is the opposite.
出处 《有色金属加工》 CAS 2011年第3期13-15,8,共4页 Nonferrous Metals Processing
关键词 组织和性能 合金 相析出 温度升高 Α相 时效 小时 针状 Cu-37Zn-2Mn-1.6Al-0.7Fe-0.7Si alloy micro-structure properties
  • 相关文献

参考文献8

二级参考文献31

  • 1李元元,夏伟,张文,罗宗强.高强度耐磨铝青铜合金及其摩擦学特性[J].中国有色金属学报,1996,6(3):76-80. 被引量:38
  • 2廖乐杰,何福忠.稀土在铜及铜合金中的作用及其应用效果[J].特种铸造及有色合金,1997,17(2):52-53. 被引量:71
  • 3肖纪美.抗断裂的材料设计[J].金属学报,1997,33(2):113-125. 被引量:15
  • 4洛阳铜加工厂中心试验室金相组.铜及铜合金金相图谱[M].北京:冶金工业出版社,1983.17.
  • 5黄伟.汽车变速器的结构与维修[M].北京:国防工业出版社,1999..
  • 6郭淑梅.轿车同步器齿环用HMn59-2-1-0.5合金的组织和性能关系研究.2000中国有色金属学会合金加工学术委员会研讨会文集[M].北京,2000..
  • 7李建明.磨损金属学[M].北京:冶金工业出版社,1989..
  • 8High TensieBrasses. Copper Development Association [J]. Potters Bar. CDA Pub. 42,1986.
  • 9Toyota Jidoana Kogyo Kabusriki Kaiaba. Copper Base Alloy Having Wear Resistance at High Temeratures [P]. Brtish Patent Specification, 1973.
  • 10WAHEED A, EIDLEY N. Microstructure and Wear of Some High-tensile Brass[M]. Journal of Materials Science, 1994.

共引文献31

同被引文献31

引证文献1

二级引证文献14

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部