期刊文献+

稳压器波动管蠕变破裂失效尺寸敏感性分析 被引量:2

Sensitivity Analysis of Creep Rupture Failure Size for Pressurizer Surge Line
下载PDF
导出
摘要 以压水堆严重事故最佳估算程序为计算工具,研究了严重事故中稳压器波动管不同失效尺寸对严重事故进程和结果的影响。计算分析表明,稳压器波动管失效尺寸设为当量直径15cm左右的破口时可获得一个相对保守的计算结果,失效尺寸在12cm以下或18cm以上时,其计算结果没有15cm情况下的严重。研究结果可为深入研究压水堆核电厂严重事故现象提供参考。 With the use of best estimate computer code of pressurized water reactor(PWR) severe accident,the impact of different pressurizer surge line creep rupture failure sizes on severe accident progress and results was studied.Calculation results show that equivalent diameter of pressurizer surge line creep rupture failure at 15 cm will receive a relatively conservative result,however,when the failure size is under 12 cm or beyond 18 cm,the calculation results are not as serious as 15 cm case.The results can be used as reference for further studying severe accident phenomena in a typical PWR nuclear power plant.
出处 《原子能科学技术》 EI CAS CSCD 北大核心 2011年第5期568-571,共4页 Atomic Energy Science and Technology
基金 海军工程大学青年基金资助项目(HGDQNJJ014)
关键词 压水堆 严重事故 稳压器波动管 蠕变破裂失效 pressurized water reactor severe accident pressurizer surge line creep rupture failure
  • 相关文献

参考文献3

  • 1VIEROW K, LIAO Y, JOHNSON J, et al. Severe accident analysis of a PWR station blackout with the MELCOR, MAAP4 and SCDAP/RELAP5 codes[J]. Nucl Eng Des, 2004, 234 (1) 129-145.
  • 2KNUDSON D L, REMPE J L, CONDIE K G, et al. Late-phase melts conditions affecting the potential for in-vessel retention in high power reactors[J]. Nucl Eng Des, 2004, 230(1): 133-150.
  • 3张龙飞,张大发,徐金良.压水堆核电厂全厂断电事故及其缓解措施[J].原子能科学技术,2008,42(11):1028-1032. 被引量:11

二级参考文献6

  • 1SEHGAL B R, KARBOJIAN A, GIRI A, et al. Assessments of reactor vessel integrity (ARVI) [J]. Nuclear Engineering and Design, 2005, 235 : 213-232.
  • 2VIEROW K, LIAO Y, JOHNSON J, et al. Severe accident analysis of a PWR station blackout with the MELCOR, MAAP4 and SCDAP/RELAP5 codes[J]. Nuclear Engineering and Design, 2004, 234: 129-145.
  • 3KNUDSON D L, REMPE J L, CONDIE K G, et al. Late-phase melts conditions affecting the potential for in-vessel retention in high power reactors [J]. Nuclear Engineering and Design, 2004, 230: 133-150.
  • 4Severe accident risks: An assessment for five U. S. nuclear power plants, NUREG-1150 [R]. Idaho: USNRC, 1990.
  • 5KRIEG R, DEVOS J, CAROLI C, et al. On the prediction of the reactor vessel integrity under severe accident loading(RPVSA)[J]. Nuclear Engineering and Design, 2001, 209: 117-125.
  • 6MARUYAMA Y, MORIYAMA K, NAKAMURA H, et al. Modeling for evaluation of debris coolability in lower plenum [ J ]. Nuclear Science and Technology, 2003, 40(1) : 12-21.

共引文献10

同被引文献6

  • 1WAGNER K C. Draft SAND Report, MELCOR 1.8.5 Analysis of Natural Circulation Flow in the Wes- tinghouse High-Pressure SF6 Experiments [R].Albuquerque..Sandia National Laboratories, 2001.
  • 2LARSON F R, MILLER J. A Time Temperature Relationship for Rupture and Creep Stress [R]. USA: ASME, 1952.
  • 3房保国.船用反应堆严重事故分析与可视化仿真研究[D].武汉:海军工程大学,2010.
  • 4LARSON F R, MILLER J. A time temperature relationship for rupture and creep stress[R]. USA: ASME, 1952.
  • 5王伟,陈力生,张帆.船用核动力装置小破口失水事故放射性后果分析[J].辐射研究与辐射工艺学报,2012,30(2):87-92. 被引量:6
  • 6吴斌,贾铭椿,龚军军.船用堆核事故状态下源项特性及计算方法研究[J].海军工程大学学报,2003,15(5):87-90. 被引量:17

引证文献2

二级引证文献5

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部