制动器底板精整模的设计

Design of Size Die for the Brake Bottom Plate

零件经过冲裁、弯曲、拉伸及其他成形工序之后,如果零件不平度有特殊要求,必须用精整模加以校平。本文分析并介绍了制动器底板精整模结构、模具的设计要点和其工作过程。

After blanking,bending,drawing and other forming process of die,when the forming parts have special requirements,must use size die to leveling.This paper analyzed and introduced the size die structure,die design points and working process.