1CHEN S C, JONG W R, CHANG J A. Dynamic mold surface temperature control using induction heating and its effects on the surface appearance of weld line [J]. Journal of Applied Polymer Science, 2006, 101: 1 174-1 180.
2THEILADE U A, HANSEN H N. Surface microstructure replication in injection molding [J]. International Journal of Advanced Manufacturing Technology, 2006, 33(1-2): 157-166.
3JANSEN K M B. Heat transfer in injection moulding systems with insulation layers and heating elements [J]. International Journal of Heat and Mass Transfer, 1995, 38(2): 309-316.
4YAO D G, KIM B. Increasing flow length in thin wall injection molding using a rapidly heating mold[J]. Polymer-Plastic Technology and Engineering, 2002 , 41(5): 819-832.
5CHEN S C, CHANG Y, CHANG T H et al. Influence of using pulsed cooling for mold temperature control on microgroove duplication accuracy and warpage of the Blu-ray Disc[J]. International Journal of Heat and Mass Transfer, 2004, 31(7): 971-980.
6YAO D G, KIM B. Development of rapid heating and cooling systems for injection molding applications [J]. Polymer Engineering & Science, 2002, 42(12): 2 471-2 481.
7CHANG P C, HWANG S J. Simulation of infrared rapid surface heating for injection molding [J]. International Journal of Heat and Mass Transfer, 2006, 49(21-22): 3 846-3 854.
8楊坤穎.感應加動態模溫即時監視與控溫方式之研究[D].台灣:中原大學,2007.
9LIN Yuwan, LI Haimei, CHEN S C, et al. 3D numerical simulation of transient temperature field for lens mold embedded with heaters [J]. International Journal of Heat and Mass Transfer, 2005, 32(9): 1 221-1 230.
