Adiabatic shear sensitivity of ductile metal based on gradient-dependent JOHNSON-COOK model

基于梯度依赖的JOHNSON-COOK模型的韧性绝热剪切敏感性(英文)

Based on the expression proposed by WANG for the local plastic shear deformation distribution in the adiabatic shear band（ASB） using gradient-dependent plasticity,the effects of 10 parameters on the adiabatic shear sensitivity were studied.The experimental data for a flow line in the ASB obtained by LIAO and DUFFY were fitted by use of the curve-fitting least squares method and the proposed expression.The critical plastic shear strains corresponding to the onset of the ASB for Ti-6Al-4V were assessed at different assigned ASB widths.It is found that the proposed expression describes well the non-linear deformation characteristics of the flow line in the ASB.Some parameters in the JOHNSON-COOK model are back-calculated using different critical plastic shear strains.The adiabatic shear sensitivity decreases as initial static yield stress,work to heat conversion factor and strain-rate parameter decrease,which is opposite to the effects of density,heat capacity,ambient temperature and strain-hardening exponent.The present model can predict the ASB width evolution process.The predicted ASB width decreases with straining until a stable value is reached.The famous model proposed by DODD and BAI only can predict a final stable value.

以基于梯度塑性理论提出的绝热剪切带内部的局部塑性剪切变形分布的理论表达式为基础,研究10个参数对绝热剪切敏感性的影响。对LIAO及DUFFY给出的Ti-6Al-4V绝热剪切带内部的1条流线的实验结果进行最小二乘曲线拟合。估算绝热剪切带宽度取值不同时的临界塑性剪切应变。理论曲线很好地反映了绝热剪切带内部流线的非线性变形特征。利用不同的临界塑性剪切应变值反算了JOHNSON-COOK模型中的一些参数。研究发现,绝热剪切敏感性随着初始静态屈服应力、功热转化因子和应变率参数的降低而降低,这与密度、热容、环境温度及应变硬化指数的影响刚好相反。所提出的模型可以预测绝热剪切带的宽度由高至低的演变过程,直到达到一个稳定值,这一点DODD和BAI模型做不到。