摘要
以南钢(南京钢铁股份有限公司)30 t精炼钢包为原型,在相似原理的基础上,通过水模型实验对钢包不同吹氩位置的合理性进行了研究.结果表明:采用单孔底吹时,最佳位置在距钢包底部中心0.55 R处.同时通过顶渣实验和喂丝点位置优化实验,确定了合适的吹氩量和合适的喂丝点位置,研究结果为优化吹氩工艺提供了依据.
The bottom argon blowing technology was studied by water model experiment based on the prototype of 30 t ladle furnace in Nanjing Iron Steel Company according to similarity principle.The results showed that the optimal location was on 0.55 R while single tuyer was applied.Meanwhile,the proper flow rate of bottom blowing argon and position of feeding wire were also determined.The results provided a theoretic basis for modification of bottom argon blowing technology.
出处
《材料与冶金学报》
CAS
2011年第3期168-171,共4页
Journal of Materials and Metallurgy
基金
国家自然科学基金资助项目(51074039)
关键词
LF精炼
底吹氩
水力学模型
均混时间
LF refining
bottom argon blowing
water model
mixing time