摘要
采用粉末冶金方法在相同的工艺条件下制备纯铜和碳纳米管含量为10%(体积分数)的铜基复合材料。在一种销盘式载流摩擦磨损试验机上考察了不同电流条件下2种材料的载流摩擦磨损性能。结果表明:纯铜和铜基复合材料的摩擦系数和磨损率均随电流的增大而增大,但是电流对纯铜材料的影响更加显著;纯铜材料的主导磨损机制是电弧烧蚀磨损,而铜基复合材料的主导磨损机制是塑性流动变形;碳纳米管可以改善铜基复合材料的载流摩擦磨损性能。
Cu matrix composite reinforced with 10%（volume fraction） carbon nanotubes（CNTs/Cu） and pure Cu bulk were prepared by powder metallurgy techniques under the same consolidation processing condition.The effect of electrical current on tribological property of the materials was investigated by using a pin-on-disk friction and wear tester.The results show that the friction coefficient and wear rate of CNTs/Cu composite as well as those of pure Cu bulk increase with increasing the electrical current without exception,and the effect of electrical current is more obvious on tribological property of pure Cu bulk than on that of CNTs/Cu composite;the dominant wear mechanisms are arc erosion wear and plastic flow deformation,respectively;CNTs can improve tribological property of Cu matrix composites with electrical current.
基金
Project(2007CB607603)supported by the National Basic Research Program of China
关键词
碳纳米管铜基复合材料
纯铜
载流
摩擦学性能
CNTs/Cu composite
pure Cu bulk
electrical current
tribological property
