摘要
本文在在选取双重坐标系的前提下,开发了用Monte—Carlo方法计算燃烧炉内辐射换热的一种较为普遍的计算程序,作为对该程序可靠性的一个验证,我们在简单的条件下计算了一些辐射换热的直接交换面积与全交换面积,结果与解析解符合的很好。最后我们就简化条件下的扁钢锭在炉内的辐射换热问题给出了一个计算结果。
Under two different coordinate systems being selected A general program,which calculates. radiant
heat interchange in a furnace by monte-carlo method,is carried out in this paper. In order to vesify this
program,Some direct exchange areas and total radiant exchange areas on simple conditions were calcu-
lated. The results show that they are very good in agreement with the theosetical results. At the end of
paper,a result about radiant heat interchange of steel ingots in a furnace on a simple condition was ob-
tained.
出处
《内蒙古科技大学学报》
CAS
1991年第1期50-54,共5页
Journal of Inner Mongolia University of Science and Technology
基金
治金部教育司资助课题
关键词
辐射换热
MONTE-CARLO方法
直接交换面积
全交换面积
区域坐标系
Radiant heat interchange
Monte Carlo method Direct radiant exchange area
Total radiant exchange area
Zone coordinate system
