新版通信工程勘察设计收费标准的研究

Study on New Edition Survey and Design Charging Standards of Communication Engineering

为使广大通信工作者能对新版(2002年)通信工程勘察设计收费标准正常应用,指出通信工程勘察设计收费国家标准中勘察和设计两个收费标准表中都缺少内插值;而设计收费标准表中既没有界定计费额度范围,工程计费额度范围与收费基价的对应关系又不明确,因此无法进行正常的计算。为此,研究了收费标准的客观规律,界定计费额的范围,确定计费额范围与收费基价的对应关系,计算各段的内插值,补充和完善收费标准。举例说明了勘察设计费的具体计算方法。

In order to make the large numbers of communication works use the 2002 edition survey and design charging standards of communication engineering normally,we introduces the national survey and design charging standards of communication engineering in which interpolation is not concluded;neither definition of charges range nor clear correspondence between the amount of engineering charging and charge benchmark was included in design charging standard sheet,which made it difficult to calculate the charging.Aiming at solving the above problems,we did the following study： the objective law of charges,definition of the amount of charging,correspondence between the amount of engineering charging and charge benchmark,interpolation calculation of each section,supplement and improvement of the charge standards.Finally the paper briefly introduces a specific calculation method for survey and design charging.