摘要
分析了汽车手制动檐口塑件的结构和工艺特点,利用Pro/E软件设计了汽车手制动檐口注塑模具。该模具采用一模两腔平衡式布局的单分型面结构,塑件卡扣的成型由斜顶机构完成。模具结构简单合理,加工成本较低。
The structure and technological characteristics of the plastic part of hand brake cornice used in the automobile was analyzed,and the corresponding injection mold was designed by using Pro/E software.The mold adopts two cavities,balance layout,single parting surface.The buckles of the plastic part are molded by angle ejecting mechanism.The mold structure is simple and reasonable,and its manufacturing cost is low.
出处
《塑料科技》
CAS
北大核心
2012年第1期84-87,共4页
Plastics Science and Technology
基金
华东交通大学校立科研基金资助项目(10JD05)
关键词
手制动檐口
分型面
PRO/E
斜顶机构
注塑模
Hand brake cornice
Parting surface
Pro/E
Angle ejecting mechanism
Injection mold
