摘要
设计了一种蓄电池板栅连铸机,该连铸机可实现蓄电池板栅的连续铸造。针对蓄电池板栅连铸过程中铅液在模具内快速凝固结晶的特点,分别进行了动模表面连续板栅型腔结构设计、定模内部供铅结构设计、模具温度控制结构设计、浇注过程气体保护结构设计,并进行了样机试制及板栅连铸试验,获得了蓄电池连铸板栅样品。
A continuous casting machine was designed herein, which had been used successfully for continuous casting battery grids. According to the characteristics of rapid solidification of molten lead in the mold during continuous casting of the grid, battery grid cave in the outer peripheral surface, molten lead passageway in the shoe, temperature control system of mold, gas shielded during the casting were designed. Trial production of continuous casting machine and test of continuous casting were carried out. The sample of grid was obtained successfully.
出处
《中国机械工程》
EI
CAS
CSCD
北大核心
2012年第1期106-108,共3页
China Mechanical Engineering
基金
重庆市科技攻关重点项目(CSTC
2009AB3058)
重庆市高校优秀成果转化项目(kjzh08215)
河南省科技发展计划资助项目(092102210093)
关键词
蓄电池
板栅
连铸
动模
定模
battery
grid
continuous casting
drum
shoe
