摘要
The momentum of strong backward flowing melt jet and the thermal action from transferred droplets are two dominating factors affecting the formation of humping bead in high speed gas metal arc welding （GMAW）. Appropriate describing the influ- ence of the distribution mode of droplet heat content in the weld pool is essential to understand the physical mechanism of humping bead formation. Based on the exper- imental results, four kinds of droplet heat content distribution modes are proposed and employed to calculate the transient evolution of the temperature field and weld pool during high speed GMAW process. Through making comparison of predicted and measured weld bead dimensions, a suitable and adaptive distribution mode of droplet heat content is found, i.e., droplet heat content is distributed in bottom layer of gouging region at the front of weld pool, and is averagely distributed in the whole layer at the rear of weld pool. The proposed mode is also validated by experimental observation of the weld pool images and measured by geometric dimensions of the weld bead.
The momentum of strong backward flowing melt jet and the thermal action from transferred droplets are two dominating factors affecting the formation of humping bead in high speed gas metal arc welding （GMAW）. Appropriate describing the influ- ence of the distribution mode of droplet heat content in the weld pool is essential to understand the physical mechanism of humping bead formation. Based on the exper- imental results, four kinds of droplet heat content distribution modes are proposed and employed to calculate the transient evolution of the temperature field and weld pool during high speed GMAW process. Through making comparison of predicted and measured weld bead dimensions, a suitable and adaptive distribution mode of droplet heat content is found, i.e., droplet heat content is distributed in bottom layer of gouging region at the front of weld pool, and is averagely distributed in the whole layer at the rear of weld pool. The proposed mode is also validated by experimental observation of the weld pool images and measured by geometric dimensions of the weld bead.
基金
supported by the project from the State Key Laboratory for Advanced Welding & Joining at Harbin Institute of Technology (No.09005)
