摘要
探讨不同紧度组织配置下机织物的平面形态特点。选取两种不同紧度的组织配置成正方形方格织物,以组织松紧比、纬纱密度、区域宽度为变化因子,计算织物区域扩约系数,建立了各因子与扩约系数的相关曲线。结果表明:方格织物扩约系数随织物组织松紧比的增大而增大,随纬纱密度的增大而先增大后减小,方格宽度对扩约系数有明显的影响。认为织物紧组织区域向松组织区域扩约需克服纱线的抗弯阻力。
Flat shape property of woven fabric in different tightness weave configuration was discussed. Square plaid was configured and selected in two different tightness weave. Ratio between weave looseness and tightness, weft density and zone width were selected as change factors, fabric zone sphincter was calculated. Related curve was estab- lished among factors and sphincter coefficient. The result shows that the sphincter is increased as fabric ratio between weave looseness and tightness adds. The factor is increased then reduced as weft density increases. The factor is affected by grid width obviously. It is considered that bending resistance should be overcome when fabric tightness weave zone is expanding to looseness weave zone.
出处
《棉纺织技术》
CAS
CSCD
北大核心
2012年第2期1-3,共3页
Cotton Textile Technology
基金
江苏省高校优势学科一期建设项目PAPD资助[苏政办发(2011)6号]
关键词
机织物
平均交织次数
纱线滑移
纬纱密度
扩约系数
Woven Fabric
Average Interweave Time
Yarn Slippage
Weft Density
Sphincter Coefficient
