期刊文献+

高温、湿热环境下氟橡胶密封圈失效研究 被引量:39

Analysis of Fluorine Rubber O-ring under High Temperature and Hygrothermal Environment
下载PDF
导出
摘要 通过开展F-108氟橡胶O形密封圈高温加速老化试验和湿热试验,分析了其在不同环境下的失效规律,评估了25℃条件下氟橡胶的贮存寿命。结果表明,70℃,85%RH和70℃,95%RH下氟橡胶的湿热老化速率分别是热空气老化速率的7.47倍和8.65倍;在热空气老化初期,由非化学因素引起的橡胶压缩永久变形远比化学反应引起的变形要大得多;氟橡胶密封圈常温下贮存寿命大约为10 a,但高温高湿环境会使其寿命大大缩短。 Through high-temperature accelerated aging test and damp heat test, the failure rule of F-108 fluorine rubber o-ring under different environments was analyzed and the storage life of F-108 fluorine rubber o-ring at 25℃ was evaluated. The results indicated that hygrothermal aging rate of fluorine rubber at 70 ℃, 85% RH and 70℃, 95% RH is 7,47 times and 8.65 times of hot air aging rate respectively; early in the hot air aging, permanent deformation of rubber compression caused by non-chemical factors is much larger than chemical factors; the storage life of fluorine rubber o-ring is about 10 years, but the life will be greatly shortened under the hygrothermal environment.
作者 常新龙 姜帆
出处 《装备环境工程》 CAS 2012年第1期23-25,38,共4页 Equipment Environmental Engineering
关键词 氟橡胶密封圈 压缩永久变形 贮存寿命 fluorine rubber o-ring permanent deformation of rubber compression storage life
  • 相关文献

参考文献10

二级参考文献16

  • 1冯连胜.固体发动机O形橡胶圈密封性能试验研究[J].固体火箭技术,1993,16(3):90-96. 被引量:4
  • 2任全彬,陈汝训,杨卫国.橡胶O形密封圈的变形及应力分析[J].航空动力学报,1995,10(3):241-244. 被引量:59
  • 3陈汝训.固体发动机的密封问题[J].强度与环境,1995,22(4):1-5. 被引量:13
  • 4左正兴,廖日东.12150柴油机橡胶密封圈的有限元分析[J].内燃机工程,1996,17(2):46-49. 被引量:33
  • 5张俭.固体火箭发动机的密封问题初探[A]..中国宇航学会推进技术会议沦文集[C].,1997..
  • 6Metcalfe R, Baset S B, Lesco R,et al.Modeling of space shuttle solid rocket O-rings [A].12th International Conference on Fluid Sealing[C].Brighton, UK, 1989.3~25.
  • 7George A F, Strozzi A, Rich J I.Stress fields in a compressed unstrained elastomeric O-ring seal and a compression of computer prediction with experimental results [A].11th International Conference on Fluid Sealing [C].Cannes, France,1987.117~137.
  • 8Green I, English C.Stresses and deformation of compressed elastomeric O-ring sealing [A].14th International Conference on Fluid Sealing[C].Firenze, Italy, 1994.83~95.
  • 9朱梅骝.弹性О形圈密封技术[J].机械工程,2000,24(4).
  • 10于金风.氟橡胶密封在固体发动机上的应用[J].固体发动机设计与研究,1994,(3).

共引文献166

同被引文献366

引证文献39

二级引证文献203

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部