期刊文献+

电弧炉氧枪搅拌特性及熔池混匀效果的试验研究

Experimental study on the stirring characteristics of oxygen lances and bath mixing in EAF
下载PDF
导出
摘要 采用1∶10水模型对100t电弧炉炉壁氧枪搅拌特性和熔池混匀效果进行了试验研究。研究了炉壁氧枪水平角、垂直角、气体流量及氧枪布置等对熔池各区域搅拌效果和混匀时间的影响。试验结果表明,相对于垂直角而言,水平角对熔池各区域的流动和混匀有更为显著的影响。熔池混匀时间随气体流量的增大而减小,但气体流量增大会导致熔池喷溅量增大,且熔池液体对炉底的冲刷增强。对比两种不同的氧枪布置方案,采用原型分布且氧枪水平角为10°时,整个熔池具有最好的混匀效果。 Stirring characteristics of wall oxygen lances and local mixing of bath were studied by 1︰10 scaled cold model of 100t capacity EAF.The effect of horizontal angle,vertical angle,gas flow rate and distributions of lances on local stirring and mixing of the bath were researched.The results showed that,relative to the vertical angle,the horizontal angle of the lances had a significant impact on the local fluid flow and mixing time.With gas flow rate increasing,the mixing time was decreased,but the splashing amount was increased and the erosion intensity of bottom lining was aggravated.Compared with the two lance distributions,the non-uniform distribution of prototype with the lance horizontal angle 10° had the best comprehensive bath mixing.
出处 《冶金能源》 2012年第1期32-36,共5页 Energy For Metallurgical Industry
基金 国家自然科学基金重点项目(51034008)
关键词 电弧炉 炉壁氧枪 冷态模型 混匀时间 EAF wall oxygen lance cold model mixing time
  • 相关文献

参考文献5

二级参考文献18

  • 1杨文远,刘炳仁,朱立宪,胡勤东,高建军,张德铭.转炉氧枪喷头的射流特性及其冶金效果[J].钢铁研究学报,1995,7(3):8-15. 被引量:9
  • 2芮树森,刘金琨,武振廷,姜茂发.底吹电弧炉熔池流场测定及数学模型[J].钢铁研究学报,1995,7(1):5-10. 被引量:2
  • 3Sampaio R S, Jones J, Vieira B J. Hot Metal Strategies for EAF Industry [A]. AISTech 2008 Proceedings [C]. Pittsburgh: Association for Iron and Steel Technology, 2008. 743-751.
  • 4Opfermann A. Energy Efficiency of Electric Are Furnaces [A]. AISTech 2008 Proceedings [C]. Pittsburgh: Association for Iron and Steel Technology, 2008. 795-808.
  • 5Harris C, Holmes G. Ferri M B. Industrial Application of Supersonic Lance: The KT System Numeric Simulation, Operating Practice, Results and Perspectives [A]. AISTeeh 2006 Proceedings [C]. Cleveland: Association for Iron and Steel Technology, 2006. 483-490.
  • 6Gates L, Fujimoto K, Okada Y. Installation of Praxair CoJet Gas Injection System at Sumikin Steel and Other EAFs with Hot Metal Charges [A]. AISTech 2008 Proceedings [C]. Pittsburgh: Association for Iron and Steel Technology, 2008. 723-731.
  • 7Banks R B, Chandrasekhara D V. Experimental Investigation of the Penetration of a High-velocity Gas Jet though a Liquid Surface [J]. J. Fluid Mech., 1963, 15(1): 13-34.
  • 8Ersson M, Tilliander A, Jonsson L. A Mathematical Model of an Impinging Air Jet on a Water Surface [J]. ISIJ Int., 2008, 48(4): 377-384.
  • 9Ersson M, Jonsson L, Tilliander A. Dynamic Coupling of Computational Fluid Dynamics and Thermodynamics Software: Applied on a Top Blown Converter [J]. ISIJ Int., 2008, 48(2): 147-153.
  • 10Asai M, Hijo H, Ito K. Simulation of the Impingement of a Liquid Jet on a Molten Iron Bath Using a Particle Method [J]. ISIJ Int., 2009, 49(2): 178-181.

共引文献13

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部