期刊文献+

多联产半焦的加压着火及燃烧特性 被引量:4

Ignition and Combustion Characteristics of Multi-Generation Semi-Coke Under Pressurization
下载PDF
导出
摘要 在Cahn TherMax 500型加压热重仪上,对煤的热电气焦油多联产半焦的燃烧特性进行了系统研究,着重考察了压力对半焦热失重特性、着火特性、燃烧产物释放特性、燃烧稳定性、燃尽及综合燃烧特性的影响.试验结果表明,随着压力的升高,半焦燃烧特性明显提高.压力从常压升高到2.4,MPa,燃烧产物释放特性指数r从0.115提高到0.590,燃烧稳定性指数RW从10.7提高到33.2,着火温度从666,℃降低到523,℃,综合燃烧特性指数S从0.49提高到2.83. Thermogravimetric analysis was carried out to study the pressurized combustion characteristics of multi- generation semi-coke in Cahn TherMax 500, focusing on the influence of pressure on thermogravimetry, ignition, pyrolytic property, combustion stability, burn out and general combustion characteristics of semi-coke. The experi- mental results indicate that the combustion characteristics of semi-coke are improved significantly with the increase of pressure. When pressure increases from ordinary pressure to 2.4 MPa, ignition temperature decreases from 666 ℃ to 523℃, while the pyrolytic property releasing index r, combustion instability index Rw and general combustion index S increase from 0.115, 10.7 and 0.49 to 0.590, 33.2 and 2.83, respectively.
出处 《燃烧科学与技术》 EI CAS CSCD 北大核心 2012年第1期27-32,共6页 Journal of Combustion Science and Technology
基金 国家高技术研究发展计划(863计划)资助项目(2007AA05Z334 2007AA050302)
关键词 热重 多联产 半焦 着火 加压燃烧 thermogravimetry (TG) multi-generation semi-coke ignition pressurized combustion
  • 相关文献

参考文献10

二级参考文献40

  • 1高正阳,阎维平,刘忠.再燃过程再燃煤粉燃料C释放特性的试验研究[J].中国电机工程学报,2004,24(10):244-248. 被引量:9
  • 2赵桂瑜,李术元,刘洛夫.碳酸盐岩干酪根催化降解生烃过程及动力学研究[J].地质科学,2005,40(1):47-54. 被引量:20
  • 3于敦喜,徐明厚.煤焦破碎的模拟研究[J].中国电机工程学报,2005,25(9):90-93. 被引量:14
  • 4韩向新,姜秀民,崔志刚,张超群.油页岩半焦燃烧特性的研究[J].中国电机工程学报,2005,25(15):106-110. 被引量:33
  • 5陈建原.博士论文[M].广州:华中理工大学,1989..
  • 6JANSSON SVEN A, ANDERSON JIM. Progress of ABB's PFBC projects[A]. In: Reuther Robot Bed. Proc of the 15th International conference on Fluidized Bed Combustion [ C ], New York: ASME Technical Publishing Department, 1999. FBC99 - 0191.
  • 7GUFFA AVSSKS, NAG P K. Bed-to-wall heat transfer behavior in a pressurized circulating fluidized bed [ J ]. International Journal of Heat and Mass Transfer, 2002, 45 : 3429 - 3436.
  • 8SHUGO HOSODA, NOBUTAKA KASHIMA, SHINJI SEKIKAWA, et al. Status of pressurized internally circulating fluidized-bed gasifier(HCFG) development project[A]. In: Reuther Robot Bed. Proc of the 15th International conference on Fluidized Bed Combustion[C]. New York: ASME Technical Publishing Department, 1999.FBC99 - 0031.
  • 9ROBERTSON A, GOLDSTEIN H, HORAZAK D, et al. Second-generation PFB plant performance with W501G gas turbine[ A ]. In:Ceiling D W ed. Proc of the 16th International conference on Fluidized Bed Combustion[C]. New York: ASME Technical Publishing Department, 2001. FBC01- 0010.
  • 10SALISBURY BRUCE A, WEINSTEIN RICHARD E, FREIER MARK D, et al. APFBC repowering for Four Comers Station uses a unique approach [ A ]. In : Ceiling D Wed. Proc of the 16th International conference on Fluidized Bed Combustion[C], New York: ASME Technical Publishing Department, 2001. FBC01 - 0053.

共引文献537

同被引文献38

引证文献4

二级引证文献23

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部