期刊文献+

风电叶片用EP胶粘剂的研究 被引量:3

Study on epoxy resin adhesive for wind power blades
下载PDF
导出
摘要 以不同增韧剂改性EP(环氧树脂)为基体树脂,采用曼尼希改性胺为固化剂制备了不同改性EP胶粘剂。研究结果表明:当增韧剂为聚氨酯(PU)预聚体时,相应的改性EP胶粘剂的粘接性能优异;在上述体系中加入玻璃纤维增强填料后,相应的改性EP胶粘剂的综合力学性能和粘接性能俱佳,其拉伸强度超过75.00 MPa、拉伸模量超过4.00 GPa、断裂伸长率超过4.00%且90°剥离强度超过10.00 kN/m,属于高韧性EP胶粘剂,并且完全满足风电叶片的使用要求。 With EP(epoxy resin) modified by different tougheners as matrix resin,a series of different modified EP adhesives were made by Mannich modified amine as curing agent. The research results showed that the corresponding modified EP adhesive had excellent bonding property when toughener was polyurethane (PU) prepolymer. The corresponding modified EP adhesive with high toughness had good combination property and bonding property, and could fully meet application requirements for wind power blades because its tensile strength and tensile modulus were more than 75.00 MPa and 4.00 GPa respectively,elongation at break and 90° peeling strength were more than 4.00% and 10.00 kN/m respectively when glass fiber as reinforcing filler was introduced into EP system modified by PU.
出处 《中国胶粘剂》 CAS 北大核心 2012年第2期30-34,共5页 China Adhesives
关键词 环氧树脂 增韧 改性胺 风电叶片 epoxy resin toughening modified amine wind power blade
  • 相关文献

参考文献11

二级参考文献36

共引文献106

同被引文献45

  • 1Wunpen Chonkaew,Narongrit So,nbatsompop,Witold Brostow.High impact strength and low wear of epoxy modified by a combination of liquid carboxyl terminated poly(butadiene-co-acrylonitrile) rubber and organoclay[J].European Polymer Journal,2013,49:1461- 1470.
  • 2Xiaodong Tian,Ye Geng,Dongqing Yin,et al.Studies on the properties of a thermosetting epoxy modified withchain-extended ureas containing hydroxyl- terminated polybutadiene[J].Polymer Testing,2011,30:16-22.
  • 3Mohammad Bashar,Uttandaraman Sundararaj,Pierre Mertiny.Microstructure and mechanical properties of epoxy hybrid nanocomposites modified with acrylic tri- block-copolymer and layered-silicate nanoclay[J] .Composites,Part A,2012,43:945-954.
  • 4Wunpen Chonkaew,Narongrit Sombatsompop,Witold Brostow. High impact strength and low wear of epoxy modified by a combination of liquid carboxyl terminated poly(butadiene-co-acrylonitrile) rubber and organoclay[J].European Polymer Journal,2013,49:1461- 1470.
  • 5Bluma G Soares,Karim Dahmouche,Vernica D,et al.Lima, characterization of nanostructured epoxy networks modified with isocyanate-terminated liquid polybutadiene[J].Journal of Colloid and Interface Science,2011,358:338-346.
  • 6Raju Thomas,Ronkay F,Czigany T,et al.A probe on the failure mechanism in rubber-modified epoxy blends:morphological and acoustic emission analysis[J].Journal of Adhesion Science and Technology,2011,25 (14) : 1747-1765.
  • 7Shulin Sun,Mingyao Zhang,Huixuan Zhang,et al.Polylactide toughening with epoxy-functionalized grafted acrylonitrile-butadiene-styrene particles[J].Journal of Applied Polymer Science,2011,122:2992-2999.
  • 8Ratna D,Banthia A K,Deb P C.Toughening of epoxy resin using acrylate-based liquid rubbers[J].Journal of Applied Polymer Science,2000,78:716-723.
  • 9Kim D S,Cho K,Kim J K,et al.Effects of particle size and rubber content on fracture toughness in rubber- modified epoxies[J].Polymer Engineering and Science,1996,36(6):755-768.
  • 10徐国平.硬PVC/FRP界面胶粘剂的研制及应用[J].中国胶粘剂,1997,6(2):21-24. 被引量:3

引证文献3

二级引证文献8

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部