期刊文献+

搭接量对螺旋折流板换热器壳程性能的影响 被引量:13

Influence of Overlap Size on Shell-side Performance of Heat Exchangers With Helical Baffles
下载PDF
导出
摘要 对螺旋折流板换热器进行数值模拟,研究相同螺旋角时搭接量对壳程对流传热充分发展段流动与传热性能的影响。结果表明,随搭接量的增大,同流量下壳程传热系数与压降均增大,而同压降下的传热系数降低。连续搭接时,轴向速度沿壳体径向逐渐降低;交错搭接后,轴向速度在搭接点前后变化趋势不同,分布均匀性变差。三角区漏流的切向速度方向与主流相反,强化了中心区域传热;而搭接区漏流的切向速度方向与主流相同,会增大螺旋旁流,不利于传热。搭接量越大,换热管表面换热量沿径向的不均匀性越强。 Numerical simulation of heat exchangers with helical baffles was carried out.The study focused on the effects of overlap size on shell-side flow and heat transfer characteristics under the same helix angle in fully developed regions.The results show that,with the increase of overlap size,both the heat transfer coefficient and pressure drop increase at identical mass flow rate,whereas the heat transfer coefficient decreases at identical pressure drop.When the adjacent baffles are arranged in a continuous manner,the axial velocities gradually decrease along the radial direction.When the baffles are connected in an overlapped manner,the variation trends of axial velocities are different before and after the overlap point,and the distributions get non-uniform.The direction of leakage's tangential velocities in triangle zone is opposite to that of the bulk flow's,which will enhance the heat transfer in central region.The direction of leakage's tangential velocities in overlapped zone is the same with that of the bulk flow's,which will increase the spiral-flow leakage and make against with the heat transfer.The bigger overlap size is,the more non-uniform radial distributions of heat transfer on tubes are.
出处 《中国电机工程学报》 EI CSCD 北大核心 2012年第8期78-84,152,共7页 Proceedings of the CSEE
基金 国家重点基础研究发展计划项目(973计划)(2007CB206900) 国家自然科学基金项目(51106090)~~
关键词 螺旋折流板 换热器 搭接量 传热 压降 数值模拟 helical baffles heat exchangers overlap size heat transfer pressure drop numerical simulation
  • 相关文献

参考文献16

  • 1Master B I,Chunangad K S,Boxma A J,et al.Mostfrequently used heat exchangers from pioneering researchto worldwide applications[J].Heat Transfer Engineering,2006,27(6):4-11.
  • 2Bell K.Heat exchanger design for the process industries[J].Journal of Heat Transfer,2004,126(6):877-885.
  • 3Wang Qiuwang,Chen Guidong,Chen Qiuyang,etal.Review of improvements on shell-and-tube heatexchangers with helical baffles[J].Heat TransferEngineering,2010,31(10):836-853.
  • 4汲水,杜文静,王鹏,程林.交错搭接螺旋折流板换热器壳程流动与传热的场协同分析[J].中国电机工程学报,2011,31(20):75-80. 被引量:15
  • 5谢公南,彭波涛,陈秋炀,王秋旺,罗来勤,黄彦平,肖泽军.管壳式换热器壳侧传热与阻力性能的实验研究与预测[J].中国电机工程学报,2006,26(21):104-108. 被引量:18
  • 6李斌,陶文铨,何雅玲.螺旋折流板换热器螺距计算的通用公式[J].化工学报,2007,58(3):587-590. 被引量:13
  • 7Kral D,Stehlik P,Van Der Ploeg H J,et al.Helical bafflesin shell-and-tube heat exchangers,Part I:Experimentalverification[J].Heat Transfer Engineering,1996,17(1):93-101.
  • 8Jafari Nasr M R,Shafeghat A.Fluid flow analysis andextension of rapid design algorithm for helical baffle heatexchangers[J].Applied Thermal Engineering,2008,28(11-12):1324-1332.
  • 9Lutcha J,Nemcansky J.Performance improvement oftubular heat exchangers by helical baffles[J].ChemicalEngineering Research and Design,1990,68(A):263-270.
  • 10Zhang Jianfei,Li Bin,Huang Wenjiang,etal.Experimental performance comparison of shell-sideheat transfer for shell-and-tube heat exchangers withmiddle-overlapped helical baffles and segmental baffles[J].Chemical Engineering Science,2009,64(8):1643-1653.

二级参考文献65

共引文献65

同被引文献138

引证文献13

二级引证文献43

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部