摘要
采用熔盐法在不同温度下制备出层状浓度梯度型LiNi1-x-yCoxMnyO2正极材料。经XRD,SEM实验分析表明:材料具有典型的α-NaFeO2层状结构,粒径在200~400nm之间。在2.75~4.5V充放电电压范围内测试,800℃得到的材料首次放电比容量为166.8mAh/g,保持率为99%;同时,在2C电流以内充放电,该材料表现出较稳定的倍率性能。
The layered cathode material LiNi1-x-yCoxMnyO2 was prepared at different temperatures in the molten salt method.Experiments were carried out to test the charge and discharge properties of the material.The XRD and SEM experiments show that the prepared material has a typical α-NaFeO2 layered structure with the particles diameter range from 200nm to 400 nm.The capacity of the prepared material at 800℃ is 166.8mAh/g with a retention of 99% in the first charge-discharge cycle,tested within the voltage cut off limits of 2.75 and 4.5 V.Besides,the results show that the material demonstrates a good rate capability.
出处
《材料工程》
EI
CAS
CSCD
北大核心
2012年第3期8-11,共4页
Journal of Materials Engineering
基金
河北省教育厅计划项目(2010288)
唐山市科学技术研究与发展计划指导项目(09130204c)
关键词
锂离子电池
浓度梯度型正极材料
熔盐法
倍率特性
lithium-ion batteries
concentration-gradient cathode material
molten salt method
rate capability