XS-ZY1000液压注射机结构与工艺参数的调整

Adjustment of the Structure and Technological Parameters of XS-ZY1000 Hydraulic Injection Machine

在设备既定的条件下,为了适应品种繁多的工程塑料、形状和精度要求各异的制品加工,尽可能地发挥设备效能,必须调整注射机的结构参数和工艺参数,可采用的措施包括:通过远程调压阀或溢流阀来调节注射压力,调节锁模力,采用注射速度分级控制,采用进油节流调速回路调节合模速度,控制塑料塑化状况,在保证质量的前提下尽量缩短工作循环时间。

Under the condition of using the same machine, the structure parameters and technological parameters of the injection machine were adjusted in order to adapt to a great variety of engineering plastics and the processing of the products with varying shapes and precision requirements and to maximize the performance of the machine. The adopted measures were included： the injection pres- sure and locking force were adjusted by the remote pressure regulating valve or overflow valve; the injection speed was regulated by the speed control circuit; the pressing speed was regulated by the inlet oil throttle speed adjusting circuit to control the plastic plasticizing state; the working cycle time was shortened in the premise of quality assurance.