期刊文献+

Effect of calcining temperature and time on the characteristics of Sb-doped SnO_2 nanoparticles synthesized by the sol-gel method 被引量:8

Effect of calcining temperature and time on the characteristics of Sb-doped SnO_2 nanoparticles synthesized by the sol–gel method
原文传递
导出
摘要 Spherical Sb-doped SnO2 (ATO) nanoparticles were synthesized by the sol-gel route, employing SnCl4.5H2O and SbCl3 as precursors in an ethanol solution. The influences of the calcining temperature and calcining time on the crystallite size, crystallinity, lattice parameters, lattice distortion ratio and the resistivity of the ATO nanoparticles were synthetically investigated. The results suggested that the ATO nanoparticles were crystallized in a tetragonal cassiterite structure of SnO2 with a highly (110)- plane-preferred orientation. The calcining temperature had a dominating effect on the crystallite size, crystallinity, lattice distortion ratios and resistivity of the ATO. As the calcining temperature increased, the average crystallite size increased, the crystallinity was promoted accompanied by a decrease in the lattice distortion ratio and a corresponding decrease in the resistivity of the ATO. X-ray diffraction (XRD) and Fourier transform infrared spectrophotometer (FTIR) analysis revealed that Sb ions could not entirely supplant the Sn ions in the SnO2 lattice for a calcining time of less than 0.5 h, even at a calcining temperature of 1000 ℃. The ATO nanoparticles calcined at 1000 ℃ for 3,0 h possessed the lowest resistivity of 10.18 Ωcm. Spherical Sb-doped SnO2 (ATO) nanoparticles were synthesized by the sol-gel route, employing SnCl4.5H2O and SbCl3 as precursors in an ethanol solution. The influences of the calcining temperature and calcining time on the crystallite size, crystallinity, lattice parameters, lattice distortion ratio and the resistivity of the ATO nanoparticles were synthetically investigated. The results suggested that the ATO nanoparticles were crystallized in a tetragonal cassiterite structure of SnO2 with a highly (110)- plane-preferred orientation. The calcining temperature had a dominating effect on the crystallite size, crystallinity, lattice distortion ratios and resistivity of the ATO. As the calcining temperature increased, the average crystallite size increased, the crystallinity was promoted accompanied by a decrease in the lattice distortion ratio and a corresponding decrease in the resistivity of the ATO. X-ray diffraction (XRD) and Fourier transform infrared spectrophotometer (FTIR) analysis revealed that Sb ions could not entirely supplant the Sn ions in the SnO2 lattice for a calcining time of less than 0.5 h, even at a calcining temperature of 1000 ℃. The ATO nanoparticles calcined at 1000 ℃ for 3,0 h possessed the lowest resistivity of 10.18 Ωcm.
出处 《Particuology》 SCIE EI CAS CSCD 2012年第3期365-370,共6页 颗粒学报(英文版)
基金 the National Natural Science Foundation of China (grant no. 50705094) "Hundred Talents Program" of Chinese Academy of Sciences (grant no.KGCX2-YW-804) for providing financial support
关键词 Sb-doped SnO2 (ATO)CalciningCharacteristicsSol-gel method Sb-doped SnO2 (ATO)CalciningCharacteristicsSol-gel method
  • 相关文献

参考文献1

二级参考文献20

  • 1[1]Ansari,S.,Boroojerdian,G.P.,Kulkarni,S.K.,Sainkar,S.R.,Karekar,R.N.& Aijer,R.C.(1996).Effect of thickness on H2 gas sensitivity of SnO2 nanoparticle-based thick film resistors.J.Mater.Sci.-Mater.Electron.,7(1),267-270.
  • 2[2]Barbi,G.B.,Santos,J.P.,Serrini,P.,Gibson,P.N.,Horrillo,M.C.& Manes,L.(1995).Ultrafine grain-size tin-oxide films for carbon-monoxide monitoring in urban environments.Sens.Actuators,B,24/25,559-563.
  • 3[3]Bhagwat,M.,Shah,P.& Ramaswamy,V.(2003).Synthesis of nanocrystalline SnO2 powder by amorphous citrate route.Mater.Lett.,57,1604-1611.
  • 4[4]Bonneau,P.R.,Shibao,R.K.& Kaner,R.B.(1990).Low-temperature precursor synthesis of crystalline nickel disulfide.Inorg.Chem.,29,2511-2514.
  • 5[5]Bonneau,P.R.,Jarvis,R.F.,Jr.& Kaner,R.B.(1991).Rapid solid-state synthesis of materials from molybdenum-disulfide to refractories.Nature,349,510-512.
  • 6[6]Cheng,H.M.,Ma,J.M.,Zhao,Z.G.& Qi,L.M.(1996).Hydrothermal synthesis of SnO2 nanocrystals.Chem.J.Chin.Univ.,17(6),833-837.(in Chinese)
  • 7[7]Crabb,E.M.(1993).Homogeneous and heterogeneous contributions to the catalytic oxidative dehydrogenation of ethane.Appl.Catal.,A,97,49-65.
  • 8[8]Durán,P.,Capal,F.,Gutierrez,D.,Tartaj,J.& Moure,C.(2002).Cerium (Ⅳ) oxide synthesis and sinterable powders prepared by the polymeric organic complex solution method.J.Eur.Ceram.Soc.,22,1711-1721.
  • 9[9]Hench,L.L.& West,J.K.(1990).The sol-gel process.Chem.Rev.,90(1),33-72.
  • 10[10]Lantto,V.(1992).In Sberveglieri,G.(Ed.),Gas Sensors:Principles,Operations and Developments (pp117-120).Dordrecht:Kluwer.

共引文献2

同被引文献48

引证文献8

二级引证文献11

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部