期刊文献+

基于有限单元法的液体晃荡数值模拟 被引量:2

Numerical Simulation of Sloshing Waves Based on the Finite Element Method
下载PDF
导出
摘要 利用位移格式的有限单元法研究液体晃荡行为。对二维刚性边界条件和三维弹性边界条件矩形储液容器液体晃荡进行分析。得到液体晃荡固有频率、自由液面瞬时高度和自由液面高度时间历程曲线等。二维刚性边界条件的结果与线性解析解具有很好的一致性,验证了有限单元法的适用性。在弹性边界条件下给出了自由液面瞬时高度、自由液面高度时间历程曲线和弹性容器的等效应力,反映了液体晃荡对弹性容器的影响。突出了基于位移格式的有限单元法在处理弹性边界条件液体晃荡问题的优势。 The sloshing waves are analyzed using the displacement-based fluid finite element method.Two kinds of tanks are analyzed with one two dimensional rigid boundary conditions and the other 3D elastic boundary conditions.The sloshing frequency,free surface instantaneous elevation and time history of free surface elevation are obtained.The results of the rigid tank are found to be in good agreement with the linear analytical solutions,which verifies the feasibility of FE method.Free surface instantaneous elevation,time history of free surface elevation and the equivalent stresses in the elastic tank are obtained to give the influence of the sloshing waves on the tank.It mainly shows the advantage of the displacementbased fluid finite element method in dealing with the sloshing wave’s problem with elastic boundary condition.
出处 《机械设计与制造》 北大核心 2012年第6期168-170,共3页 Machinery Design & Manufacture
基金 航空科学基金(2010ZA53013) 科技部863项目(2009AA04Z418) 高等学校学科创新引智计划项目(B07050)
关键词 数值模拟 有限单元法 液体晃荡 Numerical Simulation Finite Element Method Sloshing Waves
  • 相关文献

参考文献11

  • 1Raouf A.Ibrahim.Liquid Sloshing Dynamics Theory and Applications[ M ]. Cambridge University Press ,2005.
  • 2Ibrahim RA.Recent advances in liquid sloshing dynamics. Appl [J ].Mech. Rev, 2001,54(2): 133-199.
  • 3Abramson HN.The dynamic behaviour of liquid in moving containers [J ]. Report SP 106 of NASA, 1966.
  • 4刘新立,严仁军,史政,李志锋.基于MSC.Dytran的液舱晃荡分析[J].船海工程,2010,39(2):44-47. 被引量:6
  • 5毛志祥,杨觉敏.飞机整体油箱的液固耦合振动计算[J].航空学报,1990,11(11). 被引量:6
  • 6G.X.Wu, Q.W.Ma, R.E.Taylor, numerical simulaotion of sloshing waves in a 3D tank based on a finite element method[J].Appl.Ocean Res, 1998 (20) :335-337.
  • 7Mateusz Graczyk,Torgeir Moan.Structural response to sloshing excitation in membrane LNG tank[J]joumal of offshore mechanics and arctic engi- neering, 2011 ( ! 33 ): 1-9.
  • 8Ling Hou,Ren-qing Zhu,Quan Wang.The two-dimensional study of the interaction between liquid sloshing and elastic structures [J ]Journal of marine science and application, 2010(9 ) : 192-199.
  • 9Siu Wing Ora,Helen Lai Wa Chana,Piezocomposite ultrasonic transducer for high-frequency wire-bonding of microelectronies devices,2007 ( 133 ): 195--199.
  • 10Zhang Lida, Ren Lachun, Lian Lingjun,et al.Shape Design and Three- Dimensional Soild Modeling Study of Wind Turbine Blade[ C ].New York: Springer Berlin Heidelberg, 2009:2348-2352.

二级参考文献7

  • 1中国船级社.油船结构强度直接计算[M].北京:人民交通出版社,2003.
  • 2朱伯芳,有限元法原理与应用,1979年
  • 3匿名著者,结构动力学,1976年
  • 4徐芝纶,弹性理论,1960年
  • 5吴良芝,机械强度,1980年,3期
  • 6卞文杰,万力.MSC.Dytran基础教程[M].北京:北京大学出版社,2004:133-145.
  • 7王德禹,金咸定,李龙渊.液舱流体晃荡的模型试验[J].上海交通大学学报,1998,32(11):114-117. 被引量:25

共引文献9

同被引文献22

  • 1机械电子工业部洛阳拖拉机研究所.拖拉机设计手册[M].北京:机械工业出版社,1994.
  • 2Asi O.Failure analysis of a crankshaft made from ductile cast iron[J].Engineering Failure Analysis,2006,29(2):1260-1267.
  • 3Pandey RK.Failure of diesel-engine crankshafts[J].Engineering Failure Analysis,2003(10):165-175.
  • 4Yu Z,Xu X.Failure analysis of a diesel engine crankshaft[J].Engineering Failure Analysis,2005(12):487-495.
  • 5Chien W Y,Pan J,Close D,Ho S.Fatigue analysis of crankshaft sections under bending with consideration of residual stresses[J].International Journal of Fatigue,2005,27(1):1-19.
  • 6Grum J.Analysis of residual stresses in main crankshaft bearings after induction surface hardening and finish grinding[J].Journal of Automobile Engineering,2003,217(3):173-182.
  • 7Hinton R W.Failure analyses of six cylinder aircraft engine crankshafts[J].Journal of Failure Analysis and Prevention,2007,7(6):407-413.
  • 8Ren W,Li K Y.Optical measurement of residual stress at the deep-rolled crankshaft fillet[C/OL]//Society of Automotive Engineers.SAE World congress,Detroit,Michigan,USA,March,2004:8-11.
  • 9北京航空材料研究所主编,航空发动机设计材料数据手册[M].北京:中国航空发动机总公司,1989.
  • 10Wang Bai-zhi.Contact analysis and optimization design of blade anddisc assembly based on mesh deformation[J].Structural Engineering and Mechanics,2009,33(6):785-788.

引证文献2

二级引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部