期刊文献+

变形对矩形单脊波导特性的影响 被引量:1

Effects of deformations on the characteristic of rectangular single-ridge waveguides
下载PDF
导出
摘要 针对脊波导器件在生产、装配及使用中可能产生的变形,采用有限元法研究了错位变形和受力变形对矩形单脊波导衰减特性、功率容量和阻抗特性的影响。数值分析结果表明:随着脊波导变形程度的增大,衰减常数增大,功率容量和特性阻抗减小,其中下侧受力变形对矩形单脊波导的特性参数影响最大,因此在波导器件的使用过程中应尽量避免下侧受力变形。 In view of the possible deformations of ridge waveguide devices in production, assembly and use, this paper studies the effects of displacement distortion and distortion under stress on the attenuation characteristics, power-handing capability and impedance characteristics of rectangular single ridge waveguides by using the finite element method. Numerical analysis re-sults indicate that with the increase of deformations, the attenuation constant increases and the power-handing capacity and ira-pedance decrease. But lateral deformation affects the characteristic ble in the use of waveguide devices. parameters the most, so it should avoided as much as possi-ble in the use of waveguide devices.
出处 《光通信研究》 北大核心 2012年第4期52-55,共4页 Study on Optical Communications
关键词 有限元法 脊波导 衰减特性 功率容量 阻抗特性 finite element method ridge waveguide attenuation constant power-handing capability impedance characteristic
  • 相关文献

参考文献6

  • 1Cohn S B . Properties of ridge waveguide [J]. Proc IRE,1947, 35 (8) : 783-788.
  • 2Hopfer Samuel. The design of ridged waveguides [J].IRE Transactions on Microwave Theory and Tech- niques, 1955,3(5): 20-29.
  • 3陈小强,赵霞,逯迈,任恩恩.器件变形对倒梯形脊波导传输特性影响的研究[J].光通信研究,2008(1):54-56. 被引量:3
  • 4Mekay M, Helszajn J. Voltage-Current Definition of Impedance of Single-Ridge Waveguide [J].IEEE Mi- crowave and Guided Wave Letters, 1999, 9 (2): 66- 68.
  • 5Mckay M, Helszajn J. Voltage-current definition of im- pendance of double ridge waveguide using the finite el- ement method [J]. IEE Proc-Microw Antennas Propag,1998, 145(1): 39-44.
  • 6Rong Y, Zaki K. Characteristics of generalized rectan- gular and circular ridge waveguides [J].IEEE Trans- actions on Microwave Theory and Techniques, 2000, 48 (2): 258-265.

二级参考文献6

  • 1陈小强,李明,任恩恩,逯迈.两种新型双脊波导传输特性的研究[J].西安电子科技大学学报,2007,34(3):495-499. 被引量:21
  • 2Cohn S B.Properties of ridge waveguide[J].Proc IRE,1947,35 (8):783-788.
  • 3Hopfer Samuel.The design of ridged waveguides[J].IRE Transactions on Microwave Theory and Techaiques,1955,3(5):20-29.
  • 4Pyle J R.The cutoff wavelength of the TE10 mode in ridged rectangular waveguide of any aspect ratio[J].IEEE Trans,1966,14 (4):175-183.
  • 5Lu M,Leonard P J.Design of trapezoidal-ridge waveguide by finite-element method[J].IEEE Proc,Microw.Antennas Propag,2004,151 (3):205-211.
  • 6金建铭.电磁场有限元分析[M].西安:西安电子科技大学出版社,2001.

共引文献2

同被引文献9

  • 1陈小强,李明,任恩恩,逯迈.两种新型双脊波导传输特性的研究[J].西安电子科技大学学报,2007,34(3):495-499. 被引量:21
  • 2金建铭.电磁场有限方法[M].西安:西安电子科技大学出版社,2001,137-139.
  • 3Y Konishi, I-I Matsumura. Short end effect of ridge guide with planar circuit in a mounted waveguide [ J ]. IEEE Trans. Microwave Theory Tech, 1979,27 (2) : 168 - 170.
  • 4J Helszajn, M McKay. Voltage-current definition of im- pendence of double ridge waveguide using the finite ele- ment method [ J ]. IEEE Proc. Microw. Antennas Propag, 1998,145 (1) :39-44.
  • 5Yu Rong,Kawthar A. Zaki. Characteristics of Generalized Rectangular and Circular Ridge Wavguides [ J ]. IEEE Transactions on Microwave Theory and Techniques,2000, 48(2) :258 -265.
  • 6M Lu, P J Leonard. Design of trapezoidal-ridge wavegu-ide by finite element method [ J ]. IEEE Proc. Microw. Ante- nnas Propag, 2004,151 ( 3 ) : 205 - 211.
  • 7赵霞,陈小强,逯迈,任恩恩.不同变形下梯形脊波导传输特性研究[J].激光与红外,2008,38(6):590-592. 被引量:4
  • 8赵霞,陈小强.变形矩形脊波导传输特性分析[J].无线电工程,2011,41(1):35-37. 被引量:4
  • 9李向葵,陈小强,陈彩红.变形对梯形单脊波导衰减等传输特性影响[J].兰州大学学报(自然科学版),2012,48(5):124-128. 被引量:2

引证文献1

二级引证文献4

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部