摘要
This paper introduces a design to improve the radiotherapy accuracy of gamma knife. In this design, sensor is used to collect respiratory parameters and tumor displacement (caused by human respiration) model is established through optimization modeling. At the same time, data are transferred to single chip microcomputer (SCM) system by pressure sensor and then stepping motor is controlled by SCM. Finally, the intelligent positioning bed is under the control of stepping motor. As a result, the intelligent positioning bed can move reverse to respiratory law. The experimental results showed that this method can reduce the influence of respiration on tumor displacement, improving the accuracy of intelligent positioning bed with simple circuit and low cost at the same time.
This paper introduces a design to improve the radiotherapy accuracy of gamma knife. In this design, sensor is used to collect respiratory parameters and tumor displacement （caused by human respiration） model is established through optimization modeling. At the same time, data are transferred to single chip microcomputer （SCM） system by pressure sensor and then stepping motor is controlled by SCM. Finally, the intelligent positioning bed is under the control of stepping motor. As a result, the intelligent positioning bed can move reverse to respiratory law. The experimental results showed that this method can reduce the influence of respiration on tumor displacement, improving the accuracy of intelligent positioning bed with simple circuit and low cost at the same time.
