期刊文献+

含萜烯树脂丙烯酸酯乳液型压敏胶的制备与性能研究 被引量:5

Study on preparation and properties of acrylate emulsion PSA with terpene resin
下载PDF
导出
摘要 以混合丙烯酸酯为共聚单体,萜烯树脂为增黏树脂,过硫酸钾(KPS)为引发剂,十二烷基硫酸钠(SDS)、烷基酚聚氧乙烯醚(OP-10)和十二烷基二苯醚二磺酸钠盐(2A1)为乳化剂,采用预乳化半连续乳液聚合法制备压敏胶(PSA)用丙烯酸酯乳液。研究结果表明:当m(OP-10)∶m(SDS)∶m(2A1)=16.5∶3.6∶7.9、w(KPS)=0.5%、单体滴加时间为3.5 h和反应温度为80~82℃时,含萜烯树脂PSA的综合性能相对最好,其初粘力(19#钢球)和剥离强度(5.8 N/25 mm)优于不含萜烯树脂PSA,但前者的持粘力(22 h)低于后者。 With mixed acrylate as c omonomers ,terpene resin as tackifying resin,potassium persulphate (KPS) as initiator,sodium dodecyl sulfate(SDS),alkylphenol ethoxylates(OP-10) and dodecyl-benzenesulfonic acid sodium salt(2A1 ) as emulsifiers,an acrylate emulsion for pressure-sensitive adhesive(PSA) was prepared by pre-emulsified with terpene resin were better than those of PSA without terpene resin,but the former hold tack(22 h) was less than the latter hold tack when mass ratio of m(OP-10):m(SDS):m(2A1 ) was 16.5:3.6:7.9,mass fraction of KPS was 0.5%, monomers dropping time and reaction temperature were 3.5 h and 80-82 ~C respectively.
出处 《中国胶粘剂》 CAS 北大核心 2012年第8期19-22,36,共5页 China Adhesives
基金 2011年福建省工商发展资金企业技术创新专项资金项目(闽财(企)指[2011]60号)
关键词 萜烯树脂 丙烯酸酯 乳液聚合 压敏胶 terpene resin acrylate emulsion polymerization pressure-sensitive adhesive (PSA)
  • 相关文献

参考文献12

  • 1胡树文,杨玉昆.溶有增粘树脂的丙烯酸酯乳液共聚及压敏胶的性能[J].高分子学报,1997,7(6):709-714. 被引量:32
  • 2王雪荣,焦剑,黄旭东,曲忠先,孔德鹏.增粘树脂在丙烯酸酯乳液胶粘剂中的共聚改性研究[J].中国胶粘剂,2006,15(7):13-16. 被引量:13
  • 3Nakamura Y,Adachi M ,Tachibana Y,et al.Tack and viscoelastic properties of an acrylic block copolymer/ tackifier system[J]. International Journal of Adhesion & Adhesives, 2009,29 (8) : 806-811.
  • 4Nakamura Y, Sakai Y, Imamura K, et al. Effects of the compatibility of a polyacrylic block copolymer/tackifier blend on the phase structure and tack of a pressure- sensitive adhesive[J]. Journal of Applied Polymer Science, 2012,123(5) :2 883-2 893.
  • 5Chu H H, Chiang W L, Chuang K S.Viseoelastic and adhesive properties of PMMA-b-PtBA with tackifier[J]. International Journal of Adhesion & Adhesives,2012, 38(10) :89-94.
  • 6Sasaki M,Fujita K,Adachi M,et al.The effect of tackifier on phase structure and peel adhesion of a triblock copolymer pressure-sensitive adhesive[J]. International Journal of Adhesion & Adhesives, 2008,28 (7) :372-381.
  • 7胡树文,杨玉昆.STUDIES ON THE BLEND OF POLYACRYLATE EMULSIONS AND TACKIFIER RESIN EMULSIONS[J].Chinese Journal of Polymer Science,1996,14(3):261-269. 被引量:3
  • 8Akiyama S, Kobori Y,Sugisaki A, et al. Phase behavior and pressure sensitive adhesive properties in blends of poly (styrene-b-isoprene-b-styrene) with tackifier resin[J]. Polymer, 2000,41 ( 11 ) : 4 021-4 027.
  • 9Nakamura Y,Sakai Y,Adachi M,et al.Effects of compati- bility of acrylic block copolymer and tackifier on phase structure and peel adhesion of their blend[J]. Journal of Adhesion Science and Technology, 2008,22 (12) : 1 313- 1 331.
  • 10Wu G F, Wang C Y,Tan Z Y, et al.Effect of temperature on emulsion polymerization of n-butyl acrylate[J]. Procedia Engineering, 2011,18 : 353-357.

二级参考文献7

共引文献39

同被引文献75

引证文献5

二级引证文献20

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部