不锈钢厨具拉伸成型生产线拉伸料重叠检测方法

An Overlapping Detective Method for Materials on Stretch Forming Production Lines in Stainless Steel Kitchenware

介绍了一种不锈钢厨具拉伸成型生产线拉伸料重叠检测方法,该装置由驱动部分、连接部分以及执行部分组成,检测钳通过拉紧弹簧拉紧,由气缸推动检测钳向前夹取拉伸料,执行部分能通过平衡调整弹簧保持平衡。当拉伸料只有一片时,安装在检测钳后端的检测传感器有信号,当拉伸料有两片或两片以上时,检测传感器无信号,应用VisualC++编写拉伸料重叠检测控制程序,控制气缸动作,采集传感器信息,在该程序的控制下完成不锈钢拉伸料的重叠检测。现场运行表明该装置实用可靠,安装调整方便,经济性好,市场应用前景广阔。

A kind of the automatic overlapping detective device and detective method which consists of drive units, connection units and actuator units of the stainless steel materials applied in robot production lines has been introduced.The higher piece and the lower piece of detector automatic close depending on the tightening of spring,and the detector is pushed forward to sandwich and detect the materials by the cylinder,the executer units adjusts its balance through the revising balance spring.There is only one material while the detective sensor has a signal, and there are two or more materials while the detective sensor has no signal.Visual C＋＋ should be used to develop the program of overlapping detective materials, to control the state of cylinder,and to collect the signals of the sensors and the overlapping detective of stainless steel materials under the control of the program.The experiment shows that the device is reliable.It＇s convenient to install and revise ,and it＇s also economic.