期刊文献+

真空热处理对冷喷涂304不锈钢涂层组织与性能的影响 被引量:4

Effect of Vacuum Heat Treatment on Microstructure and Properties of Cold Sprayed 304 Stainless Steel Coating
下载PDF
导出
摘要 采用冷气动力喷涂技术在工业用IF钢表面制备出了304不锈钢涂层,随后对涂层进行真空热处理,研究了真空热处理对其组织、结合强度、硬度及耐蚀性的影响。结果表明:304不锈钢冷喷态涂层在1 000,1 100℃真空热处理2h后,涂层发生了回复与再结晶,组织畸变程度和硬度降低,1 100℃热处理2h后涂层的硬度达到200HV0.2;真空热处理使涂层的自腐蚀电位从冷喷态时的-319mV提高到-240mV(SCE),涂层表现出了良好的耐腐蚀性能。 304 stainless steel coating was deposited on industrial IF steel by a cold gas dynamic spraying technology, and vacuum heat treatment was applied to the coating to study the effects of the treatment on microstructure, bond strength, hardness and corrosion resistance of cold-sprayed 304 stainless steel coating. The results show that recovery and recrystallization happened after the as-sprayed 304 stainless steel coating was heat- treated at 1 000, 1 100 ℃for 2 h in vacuum, the distortion degree and hardness of the coating decreased and the coating was more compact. After vacuum heat treatment at 1 100 ℃for 2 h, the hardness of the 304 stainless steel coating achieved 200 HV0. 2. Vacuum heat treatment made the corrosion potential of the 304 stainless steel coating increased to -240 mV from -319 mV(SCE) in as-sprayed state, and the coating showed good corrosion resistaneo
出处 《机械工程材料》 CAS CSCD 北大核心 2012年第10期23-26,共4页 Materials For Mechanical Engineering
基金 国家重点基础研究发展计划"973"项目(2009CB724305)
关键词 冷气动力喷涂 304不锈钢涂层 真空热处理 组织 性能 cold gas dynamic spraying technology 304 stainless steel coating vacuum heat treatment microstructure property
  • 相关文献

参考文献11

  • 1STOLTENHOFF T, KREYE H, RICHTER H J. Ananalysis of the cold spray process and its eoatings[J]. Journal of Ther- mal Spray Technology, 2002,11 (4) : 542-545.
  • 2PAPYRIN, ANATOIAI. Cold spray technology[J]. Advanced Materials Processes, 2001,159(9) : 49-51.
  • 3PAWLOWSKI L, WILEY, CHICHESTER. The science and engineering of thermal spray coatings[M]. [S. 1. ]: [s. n], 1995.
  • 4LI W Y, LI C J, LIAO H L. Effect of annealing treatment on the microstructure and properties of cold-sprayed Cu coating [J]. Journal of Thermal Spray Technology, 2006, 15 (2) : 206- 211.
  • 5LI W Y, ZHANG C, LIAO H L. Effect of heat treatment on microstructure and mechanical properties of cold sprayed Ti coatings with relatively large powder particles[J]. Journal of Coatings Technology and Research, 2009,6 (3) : 401-406.
  • 6SUDHARSHAN P P, VISHNUKANTHAN V, SUNDARA- RAJAN G. Effect of heat treatment on properties of cold sprayed nanocrystalline copper alumina coatings[J]. Acta Ma- terialia, 2007,55 : 4741-4751.
  • 7YOO Y H, LEE S H, KIM J G, et al. Effect of heat treat- ment on the corrosion resistance of Ni-based and Cu-based amorphous alloy coatings[J]. Journal of Alloys and Com- pounds,2008,461:304-311.
  • 8孟宪明,梁永立,韩玮,赵杰,张俊宝.退火处理对冷喷涂304SS涂层组织与耐蚀性能的影响[J].材料热处理学报,2011,32(2):124-129. 被引量:5
  • 9韩玮,孟宪明,赵杰,张俊宝.真空热处理对冷喷涂304不锈钢涂层弹性模量的影响[J].材料热处理学报,2011,32(8):147-152. 被引量:2
  • 10MCCUNE R C, DONLON W T, POPOOLA O O, et al. Characterization of copper layers produced by cold gas-dy- namic spraying[J].Journal of Thermal Spray Technology, 2009 (1) : 73-82.

二级参考文献47

  • 1王爱萍,常新春,侯万良,王建强.镍基非晶合金涂层的制备与腐蚀性能[J].金属学报,2006,42(5):537-539. 被引量:12
  • 2王佳杰,王志平,霍树斌,张颖,王吉孝.超音速冷喷涂铜涂层特性分析[J].焊接学报,2007,28(4):77-80. 被引量:18
  • 3Ajdelsztajn L, Jodoin B, Schoenung J M. Synthesis and mechanical properties of nanocrystalline Ni coatings produced by cold gas dynamic spraying [ J]. Surface and Coating Technology, 2006, 201(3 -4) : 1166 -1172.
  • 4Choi H, Yoon S, Kim G, et al. Phase evolutions of bulk amorphous NiTiZrSiSn feedstock during thermal and kinetic spraying processes [J]. Scripta Materialia, 2005, 53( 1 ) : 125 - 130.
  • 5Stohenhoff T, Borchers C, Gartner F, et al. Microstructures and key properties of cold-sprayed and thermally sprayed copper coatings [ J]. Surface and Coating Technology, 2006, 200 ( 16 - 17 ) : 4947 -4960.
  • 6Li C J, Li W Y. Deposition characteristics of titanium coating in cold spraying [J]. Surface and Coating Technology, 2003, 167(2 -3) : 278 -283.
  • 7Kim H J, Lee C H, Hwang S Y. Fabrication of WC-Co coatings by cold spray deposition [ J]. Surface and Coating Technology, 2005, 191(2 -3) : 335 -340.
  • 8Gartner F, Stoltenhoff T, Voyer J, et al. Mechanical properties of cold-sprayed and thermally sprayed coatings [J]. Surface and Coating Technology, 2006, 200 (24) : 6770 - 6782.
  • 9Borchers C , Gartner F , Stoltenhoff T . Microstructural and macroscopic properties of cold sprayed copper coatings [J] . Journal of Applied Physics, 2003, 93 ( 12 ) : 10064 - 10070.
  • 10Borchers C, Gartner F, Stoltenhoff T, et al. Microstructural bonding features of cold sprayed face centered cubic metals [J]. Journal of Applied Physics, 2004, 96(8): 4288- 4292.

共引文献10

同被引文献92

  • 1陈礼顺,张斌,蔡元钢.热喷涂涂层在航空发动机上的应用及发展[J].航空制造技术,2011,0(11):34-37. 被引量:13
  • 2金云学,都春燕,王磊.电弧喷涂316L不锈钢涂层的结构与性能[J].金属热处理,2015,40(1):64-67. 被引量:6
  • 3徐滨士,李长久,刘世参,马世宁.表面工程与热喷涂技术及其发展[J].中国表面工程,1998,11(1):3-9. 被引量:124
  • 4ALKHIMOV A P,KOSAREV V F,PAPYRIN A N. A Me-thod of Cold Gas-dynamic Deposition [ J ] . Soviet Physics-Doklady,1990’35(12) :1047-1049.
  • 5ALKHIMOV A P,KOSAREV V F,NESTEROVICH N I,etal. Method of Applying Coating : Russian, 1618778 [ P ].1990-09-08.
  • 6ALKHIMOV A P,KLINKOV S V. Gas-dynamic Spraying Studyof a Plane Supersonic Two-phase [ J ]. Journal of AppliedMechanics and Technical Physics,1997,38(2) :324-330.
  • 7MCCUNE R C,DONLON W T,CARTWRIGHT E L,et al.Characterization of Copper and Steel Coating Made by theCold Gas-dynamic Spray Method [ C ]//Thermal Spray:Practical Solutions for Engineering Problems. OH, UnitedStates: ASM International Materials Park,1996 :397~403.
  • 8MCCUNE R C,PAPYRIN A N,HALL J N,et al. An Explo-ration of the Cold Gas-dynamic Spray Method for SeveralMaterials Systems [ C ]//Proceedings of the 8 th NationalThermal Spray Conference. OH,United States : ASM Interna-tional Materials Park,1995 : 1-5.
  • 9MORIMOTO J,ONODA T,SASAKI Y, et al. Improvement ofSolid Cold Sprayed Ti02 -Zn Coating with Direct Diode Laser[J]. Vacuum,2004,73(3/4) :527-532.
  • 10KIM H,LEE C,HWANG S. Fabrication of WC-Co Coatingsby Cold Spray Deposition [J]. Surface and Coatings Tech-nology ,2005 ,191 (2/3) :335-340.

引证文献4

二级引证文献30

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部