摘要
针对CENA1、S136H、2316ESR、718H和738H五种典型的预硬塑料模具钢,分别进行了显微组织观察、硬度测试、磨损试验和耐蚀性试验并进行了对比。结果表明:预硬塑料模具钢的正常显微组织为回火索氏体;综合考虑耐磨性和耐蚀性,S136H和2316ESR钢比CENA1钢更具优势;S136H钢的耐磨性最优,2316ESR钢的耐蚀性最好。
The microstructure observation, hardness testing, wear and corrosion resistance testing were performed to compare the microstructure and properties of five typical pre-hardened plastic mould steels（CENA1, $136H, 2316ESR, 718H and 738H）. The results show that the normal microstructure of the pre-hardened plastic mould steels was tempered sorbite. Considering both wear resistance and corrosion resistance, S136H and 2316ESR steels had more advantageous than CENA1 steel, the wear resistance of S136H steel was the best and the corrosion resistance of 2316ESR steel was the best.
出处
《机械工程材料》
CAS
CSCD
北大核心
2012年第10期50-53,共4页
Materials For Mechanical Engineering
基金
广东省教育部科技部企业科技特派员行动计划专项(2009B090600025)
武汉理工大学在校研究生创新研究项目(2010-ZY-CL-23)
关键词
预硬塑料模具钢
显微组织
耐磨性
pre-hardened plastic mould steel
microstructure
wear resistance
