期刊文献+

Ru对镍基单晶高温合金高温持久性能的影响(英文) 被引量:5

Effect of Ru on stress rupture properties of nickel-based single crystal superalloy at high temperature
下载PDF
导出
摘要 在真空定向炉中浇注了具有[001]方向的不含Ru和含Ru两个单晶高温合金,其它合金元素的含量基本相同,研究Ru对单晶高温合金在(980℃,250 MPa),(1100℃,140 MPa)和(1120℃,140 MPa)条件下持久性能的影响。结果表明,加入Ru能提高单晶高温合金的高温持久性能,提高作用随着温度的升高而降低。在断裂后的两种合金试样中都观察到γ′相定向粗化和筏排化,并且在(1100℃,140 MPa)和(1120℃,140 MPa)条件试样中有针状的TCP相析出,而在(980 ℃,250 MPa)条件试样中无TCP相析出。加入Ru减少了TCP相的析出数量。最后,讨论了加入Ru带来的合金组织变化进而提高合金持久性能的原因。 Two experimental single crystal superalloys, Ru-free alloy and Ru-containing alloy with [001] orientation, other alloying element contents being basically kept same, were cast in the directionally solidified furnace. The effect of Ru on the stress rupture properties of the single crystal superalloy was investigated at (980 ℃, 250 MPa), (1100 ℃, 140 MPa) and (1120 ℃, 140 MPa). The results show that Ru can enhance high temperature stress rupture properties of single crystal superalloy. The improvement effect of Ru addition on stress rupture properties decreases with increasing test temperature. The γ′ coarsening and rafting directionally are observed in Ru-free alloy and Ru-containing alloy after stress rupture test. Needle shaped TCP phases precipitated in both of alloys after stress rupture test at (1100 ℃, 140 MPa) and (1120 ℃, 140 MPa) and no TCP phase was observed in both of alloys after stress rupture test (980 ℃, 250 MPa). The precipitate volume fraction of TCP phases is significantly decreased by the addition of Ru. At last, the relationship between the microstructure change with Ru addition and improvement of stress rupture properties was discussed.
出处 《Transactions of Nonferrous Metals Society of China》 SCIE EI CAS CSCD 2012年第9期2106-2111,共6页 中国有色金属学报(英文版)
关键词 镍基单晶高温合金 RU 持久性能 Ni-based single crystal superalloy Ru stress rupture properties
  • 相关文献

参考文献16

  • 1WALSTON W S, O'HARA K, ROSS E W, POLLOCK T M, MURPHY W H. ReneN6: Third generation single crystal superalloy [C]IIKlSSINGER R D, DEYE D J, ANTON D L, CETEL A D, NATHAL M V, POLLOCK, T M, WOODFORD D A. Superalloys. Warrendale, PA: TMS, 1996: 27-34.
  • 2ERICKSON G L. The development and application of CMSX-IO [C]IIKlSSINGER R D, DEYE D J, ANTON D L, CETEL A D, NATHAL M V, POLLOCK, T M, WOODFORD D A. Superalloys. Warrendale, PA: TMS, 1996: 35-44.
  • 3ACHARYA M V, FUCHS G E. The effect of long term thermal exposures on the microstructure and properties of CMSX-I 0 single crystal superalloys [J]. Materials Science and Engineering A, 2004, 381: 143-153.
  • 4YEH A C, RAE C M F, TIN S. High temperature creep of'Ru-bearing Ni-base single crystal superalloys[C]11 GREEN K A, POLLOK T M, HARADA H, HOWSON T W, REED R C, SCHIRRA J J, WALSTON S. Superalloys. Pennsylvania, PA: TMS, 2004: 677-685.
  • 5YEH A C, TIN S. Effect of Ru on the high temperature phase stability of Ni-base single crystal superalloys [J]. Metallurgical and Materials Transactions A, 2006, 37: 2621-2631.
  • 6HOBBS R A, ZHANG L, RAE C M F, TIN S. The effect of ruthenium on the intermediate to high temperature creep response of high refractory content single crystal suepralloy [J]. Materials Science and Engineering A, 2008, 489: 65-76.
  • 7CARROLL L J, FENG Q, MANSFIELD J F, POLLOCK T M. Elemental partitioning in Ru-containing nickel-base single crystal superalloys [J]. Materials Science and Engineering A, 2009, 457: 292-299.
  • 8HAN Y F, MA W Y, DONG Z Q, LI S S, GONG S K. Effect of ruthenium on microstructure and stress rupture properties of a single crystal nickel-base superalloy [C]II REED R C, GREEN K A, CARON P, GABB P, FAHRMANN G, HURON E S, WOODARD S A. Superalloys. Pennsylvania, PA: TMS, 2008: 91-97.
  • 9ARGENCE D, VERNAULT C, DESVALLEES Y, FOURNIER D. MC-NG: Generation single crystal superalloy for future aeronautical turbine blades and vanes [C]IIPOLLOCK T M, et al. Superalloys, Warrendale, PA: TMS, 2000: 829-837.
  • 10WALSTON S, CETEL A, MACKAY R, O'HARA K, DUHL D, DRESHFIELD R. Joint development of a fourth generation single crystal superalloy [C]IIGREEN K A, POLLOK T M, HARADA H, HOWSON T W, REED R C, SCHIRRA J J, WALSTON S. Superalloys. Pennsylvania, PA: TMS, 2004: 15-24.

二级参考文献11

  • 1Tamaki H, Yoshimari A, Okayama A. In: Pollock T M eds. Superalloys 2000[C]. Warrendale: TMS, 2000:757.
  • 2Li Jiarong, Zhong Zhengang, Tang Dingzhong et al. In: Pollock T Meds. Superalloys 2000[C]. Warrendale: TMS, 2000:777.
  • 3Jackon J J, Donachie M J, Henricks R J et al. Metallurgical Transaction A [J], 1977, 8 (10): 1.
  • 4Liu L R, Jin T, Zhao N R et al. Materials Science and Engineering A[J], 2004:105.
  • 5Newell M, Devendra K, Jennings P A et al. Materials Science and Engineering A[J], 2005, 413-414:567.
  • 6Gell M, Duhl D N, Giamei A F. In: Tien J K eds. Superalloys 1980[C]. Warrendale: TMS, 1980:205.
  • 7Eart W Ross, Kevin S O'Hara. In: Kissinger Reds. Supperalloys 1996 [C]. Warrendale: TMS, 1996:19.
  • 8Dilip M Shah, Alan Cetel. In: Pollock T M eds. Superalloys 2000 [C]. Warrendale: TMS, 2000:295.
  • 9Chen Q z, Jones C N, Knowles D M. Materials Science and EngineeringA [J], 2004, 385:402.
  • 10Harris K, Wahl J B. In: Green K A eds. Superalloys 2004[C]. Warrendale: TMS, 2004:45.

共引文献22

同被引文献39

引证文献5

二级引证文献22

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部