摘要
本文从轧制稳定性、设备能力及工艺控制等方面分析研究了1450 mm热连轧机轧制超极限宽规格(W>1300 mm)产品的可行性。研究结果表明,在现有的工艺和装备条件下,轧制1350 mm以下实际宽度规格产品是基本可行的。
This article describes the feasibility of 1450 mm hot rolling mill extreme wide - gauge (w 〉 1300 mm) strip, from the aspect of roUing stability and equipment capacity and process control. The result show that, under the existing process and equipment conditions, it is basic feasible of rolling extreme wide - gauge(w 〈 1350 mm)product.
出处
《四川冶金》
CAS
2012年第3期40-43,共4页
Sichuan Metallurgy
关键词
热连轧
超极限
宽规格带钢
轧制
Hot strip mill, Over the limit, Wide gauge strip, Rolling