期刊文献+

Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement 被引量:8

Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement
原文传递
导出
摘要 This study investigated the emission characteristics of ultra.fine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35)×10^8 cm^-3. The on-board measurement results illustrated that the ultra_fine particles were strongly correlated with changes in real-world driving cycles. The particle number concentration was down to 2.0 ×10^6 cm^-3 and 2.7 ×10^7 cm^-3 under decelerating and idling operations and as high as 5.0×10^8 cm^-3 under accelerating operation. It was also indicated that the particle number measured by the two methods increased with the growth of engine load at each engine speed in both cases. The particle number presented a "U" shaped distribution with changing speed at high engine load conditions, which implies that the particle number will reach its lowest level at medium engine speeds. The particle sizes of both measurements showed single mode distributions. The peak of particle size was located at about 50-80 nm in the accumulation mode particle range. Nucleation mode particles will significantly increase at low engine load operations like idling and decelerating caused by the high concentration of unburned organic compounds. This study investigated the emission characteristics of ultra.fine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35)×10^8 cm^-3. The on-board measurement results illustrated that the ultra_fine particles were strongly correlated with changes in real-world driving cycles. The particle number concentration was down to 2.0 ×10^6 cm^-3 and 2.7 ×10^7 cm^-3 under decelerating and idling operations and as high as 5.0×10^8 cm^-3 under accelerating operation. It was also indicated that the particle number measured by the two methods increased with the growth of engine load at each engine speed in both cases. The particle number presented a "U" shaped distribution with changing speed at high engine load conditions, which implies that the particle number will reach its lowest level at medium engine speeds. The particle sizes of both measurements showed single mode distributions. The peak of particle size was located at about 50-80 nm in the accumulation mode particle range. Nucleation mode particles will significantly increase at low engine load operations like idling and decelerating caused by the high concentration of unburned organic compounds.
出处 《Journal of Environmental Sciences》 SCIE EI CAS CSCD 2012年第11期1972-1978,共7页 环境科学学报(英文版)
基金 supported the Instantaneous Emission and Environmental Impact study on Vehicle Alternative Fuel(No.10231201902) the Project of Study and Demonstration of Real Time On-Road Vehicle Emission and Pollution Warning (No.10231201700) from the Shanghai Science and Technology Commission
关键词 ultrafine particle emission emission factor diesel engine on-board emission measurement TSI EEPS ultrafine particle emission emission factor diesel engine on-board emission measurement TSI EEPS
  • 相关文献

参考文献1

二级参考文献27

共引文献8

同被引文献126

引证文献8

二级引证文献40

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部