期刊文献+

印刷线路板厂含铜污泥固化处理工艺研究 被引量:14

STUDY OF SOLIDIFICATION TREATMENT OF SLUDGE CONTAINING COPPER FROM PRINTED CIRCUIT BOARD PLANT
下载PDF
导出
摘要 研究采用水泥作固化基材固化处理某印刷线路板厂酸性废水用石灰混凝所产生的含铜、锡、金的污泥 ,对固化块在不同 pH的水中重金属Cu2 +的浸出实验结果表明 :水泥固化处理该混凝污泥效果良好 ,控制合适的条件 ,可得到混合性能好、初凝时间适当、抗压强度较好的固化块。Cu2 +的浸出率低于允许浸出浓度。混凝过程中加入硫脲硅酸钠等助剂 ,可提高固化效果。研究还对几种不同配比的固化块抗压强度进行了探讨。 The solidification characteristics of the sludge containing Cu 2+ from a printed circuit board plant by 425 # cement are investigated. The result shows that the result of solidification is good, the leaching concentration of Cu 2+ of the samples with various change ratios is lower than the nation's allowed extracted standard, and the compression strength of the samples was satisfied and increased with the addition of NaSiO_3 and(NH_2)_2CS. The solidification product can reach the requirements of natural durnping or as a road constructing material.
作者 石太宏 汤兵
出处 《环境工程》 CAS CSCD 北大核心 2000年第3期47-49,共3页 Environmental Engineering
关键词 水泥固化 石灰混凝 印刷线路板厂 废水处理 cement solidification, lime coagulation and heavy metal
  • 相关文献

参考文献4

二级参考文献1

  • 1王振成.固体废物利用及处理[M]西安交通大学出版社,1987.

共引文献40

同被引文献147

引证文献14

二级引证文献84

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部