摘要
防污闪硅橡胶是具有RTV工艺特性的特种功能的液态涂料,而真正具有防污闪功能的却是其固化后的涂层。液态涂料转化为固化涂层的过程—即喷涂施工—显然是防护质量的重要一环。现行标准中对施工的规范性条款制订的较少,加之施工队伍参差不齐,因此每个/次现场喷涂形成的涂层质量不尽相同。文中以多年的现场监管实践,总结出防污闪硅橡胶喷涂施工中必须管控的关键节点,从而提高喷涂施工的过程质量和最终涂层质量。
The anti-pollution-flashover silicone rubber is a kind of liquid paint of special functions with RTV process characteristics. It is the cured coating that can prevent pollution flash. Obviously, the conversion from liquid paint into cured coating -namely spray painting- is the key part to decide the quality of protection. There are few normative terms about spray painting in present standards and the level of construction teams is uneven. Therefore every-time the quality of the coating formed by the site spray painting is not the same. According to the experience of site supervisions in past years, the key node that must be controlled in the spray painting of the anti-pollution-flashover silicone rubber is summed up to improve the quality of the spray painting process and the final coating quality.
出处
《江苏电机工程》
2012年第6期58-60,64,共4页
Jiangsu Electrical Engineering
关键词
防污闪RTV硅橡胶
喷涂
质量
管控
anti-pollution-flashover RTV silicone rubber
spray painting
quality
control
