摘要
针对溢流阀体零件,分析其原加工工艺方案,指出其不足;提出改进后的加工方案,进行加工效果的对比,并总结该零件的数控加工技巧及注意事项。
The old working scheme for the spillover valve part was analyzed, and its deficiency was pointed out. A modified scheme was presented. Processing effects of the two schemes were compared. Finally, processing techniques and notices were summed up.
出处
《机床与液压》
北大核心
2013年第2期66-67,共2页
Machine Tool & Hydraulics
关键词
典型零件
加工工艺
改进
加工技巧
Typical part
Processing technology
Improvement
Processing techniques
