摘要
利用扫描电镜、X射线衍射仪等研究了一种镍基单晶合金的短时(小于16h)高温氧化行为。结果表明:该合金在900~1 100℃空气中氧化时,随着氧化温度的升高和氧化时间的延长,氧化速率增加;合金在900℃氧化16h后形成的氧化膜不完整,致密性很低,氧化产物主要为Al2O3、NiO、Cr2O3和TiO2的混合物;在1 000℃氧化16h后形成了完整的、致密性较高的Cr2O3和Al2O3氧化膜;在1 100℃氧化16h后,氧化层中生成了块状NiCr2O4尖晶石,局部区域的氧化膜较为疏松,并且伴有部分脱落。
Short time (less than 16 h) oxidation behavior of a Ni-based single crystal superalloy at high tempereture8 wee etudied by scanning electron microscopy and X-ray diffraction. The results show that the oxidation rate increased with the increase of oxidation temperature and time when the tested alloy was oxidized at 900- 1 100 ℃ in cir. The oxidation products were comprised of Al2O3, NiO, Cr2O3 and TiO2 after the alloy was oxidized at 900 ℃ for 16 h, and the oxidation film with low compact was incomplete. After the alloy was oxidized at 1 000℃ for 16 h, the complete and compact oxidation film of Cr2O3 and Al2O3 was formed. After the alloy was oxidized at 1 100 ℃ for 16 h, the bulk NiCr204 with spinelle structure were obtained, and the partial oxidation film was loosener and with part dropping.
出处
《机械工程材料》
CAS
CSCD
北大核心
2013年第3期25-27,31,共4页
Materials For Mechanical Engineering
关键词
镍基单晶合金
短时氧化行为
氧化膜
尖晶石
Ni-based single crystal superalloy short time oxidation behavior oxidation film spinelle