摘要
在对脉冲形成线进行充电时,由于充电时间较短,以及形成线具有一定的长度,往往会使得充电电压在脉冲形成线上存在一定的不均匀性,从而影响到负载输出电压。对此进行了理论和模拟研究,分析了引起充电不均匀的原因和机制;在此基础上,通过求解不均匀充电初始条件下的电报方程,得到负载输出电压,并进行了模拟。结果表明,充电不均匀会引起负载输出电压平顶的"起伏"。
When a pulse forming line （PFL） is being charged, the voltage will be not the same on the PFL for the short charging time and certain length of the PFL. Therefore, the output voltage on the load resistance is also changed. This is researched in theory and simulation in this paper. First, the mechanism of nonuniform charging is studied, and output voltage is calculated in this situation based on the telegraph equation with the initial condition of nonuniform charging. Then, the circuit simulation is carried out to verify the results of theoretical analysis. It is shown that, the flat of the output voltage turns to be up- and-down due to nonuniform charging.
出处
《强激光与粒子束》
EI
CAS
CSCD
北大核心
2013年第5期1320-1324,共5页
High Power Laser and Particle Beams
基金
国家高技术发展计划项目
关键词
脉冲形成线
充电不均匀
电报方程
脉冲平顶
pulse forming line
charging nonuniform
telegralJh equation
flat of pulse
