摘要
应用UG6.0软件设计OPPO公司充电器外壳注射模,分析了塑件结构及成型工艺,进行了模具结构设计,模具采用斜导柱侧向抽芯,使模具结构简单合理,绘制模具装配图并阐述了此副模具的分型过程。
An injection mould for a charger casing was designed by UG 6.0 based on analysis on the structure characteristics and moulding process of the part. The application of side core-pulling via angle pin simplifies the mould structure. The assembly drawing and parting process were also presented.
出处
《模具工业》
2013年第4期50-52,共3页
Die & Mould Industry
关键词
三维建模
充电器外壳
注射模
装配图
3D modeling
charger casing
injection mould
assembly drawing