摘要
设计并制作了一个W波段的极化器,设计参数为金属丝直径100μm,间距300μm.实测结果表明,金属丝直径和间距的均值分别为100.3μm,300.2μm;标准差为5.2μm,8.3μm,表明极化器具有较高的加工精度和良好的均匀性;同时其表面平整度优于30μm.另外,测试了极化器的透射系数以及极化器作为可变衰减器时的透射系数,测试结果与理论计算结果具有良好的一致性,具有良好的极化性能.
This paper demonstrates the designing and fabrication process of a W-wave polarizer with fine metal wires. The wires were designed to be 100 μm in diameter and 300 μm between each other. The mean values of these two parameters of the fabricated wire are 100.3 μm and 300.2 μm, with the standard deviations 5.2 μm and 8.3 μm respectively. Results show that the polarization grid has high fabrication precision and uniformity, and the polarizer surface flatness is better than 30 μm. In addition, the power transmission coefficient was measured. The actual measurement results and theoretical calculation results agree with each other perfectly. The polarizer fabricated by this new method has excellent performance.
出处
《红外与毫米波学报》
SCIE
EI
CAS
CSCD
北大核心
2013年第2期176-180,共5页
Journal of Infrared and Millimeter Waves
基金
国家自然科学基金(41105007)~~
关键词
极化器
自立式线栅
W波段
加工工艺
polarizer
free-standing wire girds
W-band, manufacture