面向即插即用的物联网传感设备数据采集系统

Plug-and-Play Data Acquisition System for Sensing Equipment of Internet of Things

在物联网中,每次新传感设备的接入都需编写复杂、繁琐的数据采集程序代码。本文提出了一种能够对物联网传感设备实现即插即用的数据采集软件系统设计方法,该系统基于本文提出的一种新的接口广播即插即用通信协议(IP-PCP),在不需要配置和额外操作的情况下可以对接入系统的传感设备实现数据采集。针对目前无法使用该协议的传感设备,设计了软件中间件以实现该类传感设备的即插即用。通过实验验证了该设计方法的有效性,采用该方法可明显提高数据采集软件系统的设计效率。

In the inernet of things, each time a new sensor device access to must experience a process of write complex and tedious code for data acquisition. This paper presented a data acquisition system which was based on a new interface broadcast protocol IPPCP capable of realizing internet of things instruments plug-and-play. Without the need for configuration and additional operating conditions, the system could access system sensing device and realize data acquisition. For sensor equipments did not support IPPCP, a software middleware was specially designed to achieve the sensing device plug-andplay function. Experimental results show that the plug-and-play networking sensing equipment data acquisition system meets the common plug-and-play function requirement of sensing equipment.