期刊文献+

Cu-Zn-Al_2O_3-ZrO_2催化剂上甲醇部分氧化-蒸气重整耦合制氢反应动力学 被引量:1

Kinetics of hydrogen production on Cu/Zn/Al_2O_3/ZrO_2 catalyst by partial oxidation and steam reforming of methanol
下载PDF
导出
摘要 在改进的共沉淀法制得的Cu-Zn-Al2O3-ZrO2催化剂上常压连续流动微反应器中研究甲醇部分氧化-蒸气重整耦合制氢反应动力学。实验测得甲醇∶水∶氧=0.45∶0.45∶0.10;1.5∶1.0∶0.20和1.0∶2.0∶0.20三种摩尔配比,200~340℃温度范围内的动力学实验数据,建立了动力学模型,确定了动力学参数。 The reaction kinetics of hydrogen production by partial oxidation-steam reforming of methanol was re- searched,used the Cu/Zn/A1203/ZrO2 catalyst prepared by modified co-deposition method. The experimental datas were measured in a stainless steel micro-reactor at normal pressure and within 200-340℃,in the mole ratio of CH3OH: H2O: 02=0. 45..0. 45:0. 10,1.5:1.0:0. 20 and 1.0:2. 0:0. 20, respectively. The kinetics model for partial oxidation-steam refor- ming of methanol was developed. And the parameters of this model were determined.
出处 《化工新型材料》 CAS CSCD 北大核心 2013年第5期142-144,147,共4页 New Chemical Materials
关键词 部分氧化-蒸气重整 甲醇制氢 燃料电池 动力学 partial oxidation-steam reforming, methanol, fuel cell, kinetics
  • 相关文献

参考文献11

  • 1Sopian K,Wan D,Wan R.[J].Renewable Energy,2006,31 (5):719-727.
  • 2Atilla B.[J].International Journal of Hydrogen Energy, 2005,30(11):1181-1212.
  • 3Denver C,Norman M.[J]. Journal of Power Sources,2005,147(1-2):72-84.
  • 4李文兵,齐智平.质子交换膜燃料电池研究进展[J].化工科技,2005,13(4):55-59. 被引量:5
  • 5刘志祥,毛宗强,王诚.质子交换膜燃料电池模型研究现状[J].电池,2004,34(1):56-58. 被引量:6
  • 6Pan Liwei,Wang Shudong.[J].International Journal of Hydro-gen Energy,2005,30(9):973-979.
  • 7Choi Y,Stenger H G.[J].Journal of Power Sources, 2005,142(1-2):81-91.
  • 8Lindstrom B,Pettersson L J.[J].International Journal of Hy-drogen Energy,2001,26(9):923-933.
  • 9彭必先,甘昌胜,闫天堂.甲醇水蒸汽催化重整过程的研究进展[J].化学进展,2004,16(3):414-421. 被引量:17
  • 10Ahmed D R,Lee S H D, Kumar R, Krumpelt M.Partial oxida-tion reformer development for fuel cell vehicles[C].Proceedingsof the Intersociety Energy Conversion Engineering Conference.Honolulu, 1997,843-846.

二级参考文献45

  • 1赵国方.燃料电池的开发现状和进展[J].江苏化工,1994,22(1):1-5. 被引量:6
  • 2陈延禧.聚合物电解质燃料电池的研究进展[J].电源技术,1996,20(1):21-27. 被引量:37
  • 3[1]Amphlett J C,Baumert R M,Mann R F,et al.Performance modeling of the Ballard Mark IV solid polymer electrolyte fuel cell( Ⅰ ).Mechanistic model development [J].J Electrochem Soc,1995,142(1):1-8.
  • 4[2]Dannenberg K,Ekdunge P,Lindbergh G.Mathematical model of the PEMFC [J].J Appl Electrochem,2000,30(12):1377-1 387.
  • 5[3]Springer T E,Zawodzinski T A,Gottesfeld S.Polymer electrolyte fuel cell model [J].J Electrochem Soc,1991,138 (8):2 334-2342.
  • 6[4]Nedjib D,Lu D.Influence of heat transfer on gas and water transport in fuel cells [J].Int J Therm Sci,2002,41:29-40.
  • 7[5]Springer T E,Wilson M S,Gottesfeld S.Modeling and experimental diagnostics in polymer electrolyte fuel cells [J].J Electrochem Soc,1993,140(12):3513-3526.
  • 8[6]Bernardi D M,Verbrugge M W.Mathematical model of a gas diffusion electrode bonded to a polymer electrolyte [J].AIChE Journal,1991,37(8):1151-1163.
  • 9[7]Bernardi D M,Verbrugge M W.Mathematical model of the solidpolymer-electrolyte fuel cell [J].J Electrochem Soc,1992,139(9):2477-2491.
  • 10[8]Singh D,Lu D M,Djilali N.A two-dimensional analysis of mass transport in proton exchange membrane fuel cells [J].Int J Engineering Science,1999,37(4):431-452.

共引文献25

同被引文献9

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部