等离子喷涂LaTi_2Al_9O_(19)热障涂层的微观组织结构及热物理性能

Microstructure and Thermo-physical Properties of Plasma Sprayed LaTi_2Al_9O_(19) Thermal Barrier Coatings

第一代热障涂层(TBCs)由氧化钇部分稳定的氧化锆(YSZ)陶瓷隔热层和金属粘结层组成,该涂层长期使用温度低于1 200℃。随着先进航空发动机向着高推重比发展,迫切要求发展新一代超高温、高隔热热障涂层材料。LaTi2Al9O19(LTA)在1 500℃长期保持相稳定,是一种非常有前景的超高温热障涂层候选材料。本文采用大气等离子喷涂(APS)制备了LTA涂层,研究了喷涂工艺对涂层微观组织结构和热物理性能的影响。结果表明沉积态涂层中含少量的非晶态,在860℃和1 130℃出现晶化峰。等离子喷涂过程中La2O3挥发量较多,导致沉积态涂层中La元素与原始粉末相比含量偏低,而其他组分的化学成分随喷涂功率变化不大。LTA涂层的热扩散系数在1 400℃下为0.3～0.4mm2.s-1,热导率为1.1～1.6W.m-1.K-1。1 050℃经过20小时热处理后,得到晶化的涂层在晶化温度范围内的热扩散系数和热导率值均增大。随着喷涂功率减小,涂层孔隙率增加,热导率减小。

Conventional thermal barrier coatings （TBCs） consisting of a yttria stabilized zirconia （YSZ） ceramic coat and a metallic bond coat for industrial application cannot work long above 1 200 ℃. With aero-engines developing towards higher thrust-to-weight ratio, it is necessary to develop new ceramic coating materials with better thermal barrier performance for ultra-high temperature application. LaTi2 AI9019 （LTA） was proposed as a promising candidate due to its excellent phase sta- bility at temperatures above 1 500 ℃. In this paper, the LTA coatings were produced by atmospheric plasma spraying （APS） and their microstructures and thermo-physical properties were investigated. There were some amorphous phases in the as-sprayed coatings and crystallization of the coatings occurred at 860 ℃ and 1 130 ℃, respectively. Due to the volatili- zation of La2 03 during spraying, the concentration of La in the sprayed coating was relatively lower than that in the powder, while the other elements didn＇t show apparent changes in the compositions. The thermal diffusivity of the LTA coatings ranged from 0.3 to 0.4 mm2 · s-1 at 1 400 ℃and the corresponding thermal conductivity were in the range of 1. 1 to 1.6 W · m-1 · K-1 The coating porosity increased as the spraying power decreased, while the thermal conductivity decreased with increasing spraying power.