数控火焰切割机改造为等离子切割技术要点

The Numerical Control Flame Cutter Transforms for the Plasma Cutting Technology Main Point

通过对现有数控火焰切割机进行技术改造,更换必须的设备部件和附件,成功地改造成为一台数控等离子切割机床,关键切割技术参数达到预期要求,使用效果良好。

This article through carries on the technological transformations to the existing numerical control flame cutter, the replacement must the equipment component and the appendix, successfully transforms into a numerical control plasma cutting engine bed, the key cutting technical parameter achieved the anticipated request, the use effect is good.