摘要
设计了一种基于USB3.0和FPGA的多串口传输系统,以实现超高速数据传输。介绍了系统的硬件设计框架及系统的软硬件设计流程,给出了系统软件设计框图、FPGA设计逻辑模块以及时序。最后给出了实验结果,验证了该系统的可行性。
This article describes a multi-serial transmission system based on USB3.0 and FPGA to realize ultra-high-speed data transmission. Firstly, this article introduced the design framework of the system about hardware design; followed by the introduction of the system＇s hardware and software design processes ,the system software design diagram ,the FPGA design logical module as well as the timing; finally, given the experimental results and verified the feasibility of the system.
出处
《电子技术应用》
北大核心
2013年第9期129-131,共3页
Application of Electronic Technique
基金
陕西省教育厅自然科学基金资助项目(11JK1000)
西安工程大学博士科研启动基金项目(BS0722)
西安工程大学教改项目(2010JG12)
关键词
USB3
0
多串口
超高速数据传输
USB3.0
multi-serial
ultra-high-speed data transmission
