摘要
控制棒落棒性能验证是核电厂安全分析的重要部分,研制驱动线落棒历程计算程序有利于验证和改进控制棒驱动线设计。基于驱动线结构特点,分析运动组件的受力情况并进行分解,选择理论或数值方法逐一求取各分力的瞬态值,从而建立驱动线落棒历程的循环步进计算程序。利用秦山核电二期工程驱动线落棒性能试验数据对理论模型和程序计算结果进行对比验证。结果证明:所建立的驱动线落棒历程计算程序适用于压水堆驱动线系统,能正确地对运动组件落棒受力与运动历程进行模拟。
The validation of control rod drop performance is an important part of safety analysis of nuclear power plant. Development of computer code for calculating control rod drop course will be useful for validating and improving the design of control rod drive line. Based on structural features of the drive line, the driving force on moving assembly was analyzed and decomposed, the transient value of each component of the driving force was calculated by choosing either theoretical method or numerical method, and the simulation code for calculating rod cluster control assembly (RCCA) drop course by time step increase was achieved. The analysis results of control rod assembly drop course calculated by theoretical model and numerical method were validated by comparing with RCCA drop test data of Qinshan Phase Ⅱ 600 MW PWR. It is shown that the developed RCCA drop course calculation code is suitable for RCCA in PWR and can correctly simulate the drop course and the stress of RCCA.
出处
《原子能科学技术》
EI
CAS
CSCD
北大核心
2013年第9期1584-1589,共6页
Atomic Energy Science and Technology
基金
国家科技重大专项资助项目(2011ZX06002-002)
关键词
驱动线
控制棒组件
落棒历程
drive line
control rod assembly
drop course